00194081-01.pdf - 第120页
5 Tasks on the machine User Manual S IPLACE CF 5.3 Carrying out a walk-through inspection Software Version SR.408.xx03/2006 US E dition 120 5.3.5 Using spi ndles for large t ape reels Æ Inser t spindles into th e separat…
User Manual SIPLACE CF 5 Tasks on the machine
Software Version SR.408.xx 03/2006 US Edition 5.3 Carrying out a walk-through inspection
119
5.3.4 Inserting separating plates in the component trolley tape container
Æ Insert the separating plates as shown in Fig. 5.3 - 2 and remember that the smallest division of
the tape container is a 2x division. This will help avoid placement errors.
Æ Check that the separating plates engage in the same positions on both guide rails. Otherwise
the separating plate will be offset or bent.
5
Fig. 5.3 - 2 Inserting separating plates in the component trolley tape container
(1) Guide rail for the separating plates
(2) Tape container
(3) Waste tape container
(4) Supporting rod for the separating plates
(5) Separating plate
5 Tasks on the machine User Manual SIPLACE CF
5.3 Carrying out a walk-through inspection Software Version SR.408.xx03/2006 US Edition
120
5.3.5 Using spindles for large tape reels
Æ Insert spindles into the separating plates when using large tape reels.
PLEASE NOTE 5
We recommend that you use spindles if the tape reel diameter exceeds 15" (381 mm). This will
ensure that the feeder modules operate reliably.
Fig. 5.3 - 3 Inserting spindles for large reels
(1) Component trolley
(2) Position of the spindles
(3) Separating plate
(4) Spindle (enlarged)
User Manual SIPLACE CF 5 Tasks on the machine
Software Version SR.408.xx 03/2006 US Edition 5.4 Setting up the feeder modules
121
5.4 Setting up the feeder modules
5
Fig. 5.4 - 1 Component feeder table with 20 locations for S feeder modules
(1) S feeder module
(2) Centering pin
(3) Centering ball
(4) Component table
(5) Connecting cable for the S feeder module