00194081-01.pdf - 第172页
6 Component handling User Manual S IPLACE CF 6.5 Waffle-pack changer Software Version S R.408.xx 03/2006 US Edition 172 6.5.5 Controls and displays The EME RGENCY STOP butto n and the switch fo r changing the speed a re …
User Manual SIPLACE CF 6 Component handling
Software Version SR.408.xx 03/2006 US Edition 6.5 Waffle-pack changer
171
6.5.4 Inserting the magazine carrier
The magazine carrier is checked to ensure that it was inserted correctly.
6
Fig. 6.5 - 4 Position of the magazine carrier - plan view
6
(1) Transport direction
(2) Driving groove
(3) Magazine storage unit
(4) Control groove
(5) Driving groove
6
Make sure that the driving grooves (item 2 and 5) of the magazine carrier point forward in the
direction of travel (see Fig. 6.5 - 4
).
The control grooves (item 4) of the individual magazine carriers must be above one another and
point towards the magazine storage unit (item 3).
6 Component handling User Manual SIPLACE CF
6.5 Waffle-pack changer Software Version SR.408.xx 03/2006 US Edition
172
6.5.5 Controls and displays
The EMERGENCY STOP button and the switch for changing the speed are located on the back
of the waffle-pack changer.
Slow key
It is possible to reduce the speed for waffle-pack trays with small components that could fall out
of their pockets if the tray is traveling quickly.
Press the Slow key.
All the waffle-pack trays travel at a slower speed.
EMERGENCY STOP button
Press the EMERGENCY STOP button. The power supply is switched off and the entire system
stops.
6
Fig. 6.5 - 5 WPC - controls
6
(1) EMERGENCY STOP button
(2) "Slow" key
(3) Safety doors
User Manual SIPLACE CF 6 Component handling
Software Version SR.408.xx 03/2006 US Edition 6.5 Waffle-pack changer
173
6.5.6 Safety equipment
EMERGENCY STOP button
The entire system, i.e. SIPLACE CF and waffle-pack changer, is stopped immediately.
You can then either continue or cancel placement. Check whether there are any incomplete
PCBs remaining.
Safety doors
When the safety doors are opened, the power to the waffle-pack changer is switched off and the
sequence of waffle-pack changer functions stops. It resumes its functions when the safety doors
are closed.
CAUTION 6
Do not open the safety doors of the waffle-pack changer while it is picking up a component. 6
6.5.7 Installing the waffle-pack changer
Æ Before you push the waffle-pack changer into the placement machine, remove the top part of
the fine pitch camera.
CAUTION DANGER OF TIPPING 6
The waffle-pack changer runs on wheels. However, these are only suitable for short distances, i.e.
for docking in and out of the placement machine. Given the danger of tipping, use a suitable pallet
jack for longer distances (item no. 00123141-01). 6
Æ Carefully push the WPC into location 1 on the machine. The docking pins of the WPC must
protrude over the docking grooves in the SIPLACE CF.
Æ Check the measurement (87 +/- 0.5 mm) from the bottom edge of the magazine carrier to the
top edge of the component feeder table (see Fig. 6.5 - 6
).