00193790-01.pdf - 第111页
Installation and Getting Started with CACCIA 2 English Issue 07/2004 2.10 O verview of the J umper Settings for Individual Subsystems 45 2.10.2.3 CAN Processor Board 16 Bit The 16 BIT CAN Process or is used f or dif fe r…
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
44
2.10.2.2 Vision Board (analog)
The vision board is connected on the top of the head interface. That board is used on the gantry
with a C&P head and Twin head.
Fig. 2 - 34 Vision board
Legend
(1) Connector illumination PCB camera
(2) Connector PCB camera
(3) LED‘s P15V - 15Volt / Vcc - Power supply vision board
(4) DIP Switch
(5) CAN Processor 16 Bit (additional board on the vision board)
(6) DC/DC Converter 15 → 5V for visionsystem.
4
5
1
3
2
6
Installation and Getting Started with CACCIA 2 English
Issue 07/2004 2.10 Overview of the Jumper Settings for Individual Subsystems
45
2.10.2.3 CAN Processor Board 16 Bit
The 16 BIT CAN Processor is used for different functions of the following units:
– Vision board, communication and control via the ICOS system.
– Main board Twin head, control the vacuum generator.
– Vision board for the stationary IC (FC) - Camera, communication and control via the ICOS
system in sector 2 and 4.
Fig. 2 - 35 16 Bit Processor
Description 7 Segment display (Standard mode "." flashed):
– After switch ON the machine appears "0" on the display
– Display "b" Bios is started.
– Display flash alternately "b" and "." → none Application available or can not started.
– Display "-I" und "I-" Application is loaded and now starts.
– The "." on the display flashed.
(1) 7 Segment display
(2) LED red at the manual RESET on
the Processors
(3) 16 Bit Processor
2
3
1
2 English Installation and Getting StartedwithCACCIA
2.10 Overview of the Jumper Settings for Individual Subsystems Issue 07/2004
46
2.10.2.4 Head Adapter for 6/12 C&P Head
At the head modularity we can use the same head adapter for the 6 and 12 segment C&P heads.
The head adapter must be exchanged if you mounting the Twin head.
Fig. 2 - 36 Head adapter for 6/12 C&P head
Legend
(1) X6-X9 Connector for CAN Processor board’ 80C515C 8Bit
(2) X2/X3 Connector for the stepping motor board
(3) X10 Connector vacuum board
(4) X12 Dp station (motor, track signal)
(5) X26 Option component sensor
(6) X13/14 connector for the flat cable to the intermediate distribution board
(7) Connector to the head interface
1
2
45
3
6
7
LED‘S