00196428-0102_AI_Reconfig_Kit_X-Serie_CPP_DE+EN.pdf - 第118页

2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series Head Reconfiguration Kit 2.8 Removing the Placement Head Issue 03/2010 118 2 X Loosen and remove the four fixing screws of the placement he ad…

Head Reconfiguration Kit 2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series

Issue 03/2010 2.8 Removing the Placement Head

117

X Open the clips and disconnect the component camera plugs.

Opening the

clips

Disconnecting the plugs

2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series Head Reconfiguration Kit

2.8 Removing the Placement Head Issue 03/2010

118

X Loosen and remove the four fixing screws of the placement head and lift the placement head

off.

CAUTION:

Tightly hold the placement head at its handle, when loosening and removing the fixing

screws, to prevent the head from falling down and being damaged! 2

Head screws

on the left on the right

Head Reconfiguration Kit 2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series

Issue 03/2010 2.8 Removing the Placement Head

119

2.8.4 Removing the Head Adapter Board

X Remove the six screws and lift off the head adapter board (see photos below).

When switching to a C&P20 head this step can be omitted. In this case, however, the cable

holder must be reinstalled.

X Also remove the cable clip and the hexagonal bolt.

Head adapter board

6 screws

Cable clip

Hexagonal bolt