00196428-0102_AI_Reconfig_Kit_X-Serie_CPP_DE+EN.pdf - 第80页
2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series Head Reconfiguration Kit 2.7 Installing the CPP Placement Head Issue 03/2010 80 2 CAUTION: Danger of crashing When using the CPP head together…
Head Reconfiguration Kit 2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series
Issue 03/2010 2.7 Installing the CPP Placement Head
79
2.7 Installing the CPP Placement Head
The CPP placement head can only be used together with a component trolley docking unit of the
X-series and X-feeder modules. 2
2.7.1 CPP with MTC2 Option
2
– When an MTC is present, the head must be installed in the high position. The installation height
is monitored during the head reference run.
– In SW 702, the CPP head is not released for a two-gantry placement area with MTC. In this
configuration, there is no nozzle changer available at the location with the MTC.
NOTE:
For further information on MTC2, please refer to the Assemby Instructions "MTC2 on
Component Trolley Docking Unit, X-S" [00194725-xx] and the Installation Instructions
"MTC2 on SIPLACE HF" [00193897-xx]. 2
2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series Head Reconfiguration Kit
2.7 Installing the CPP Placement Head Issue 03/2010
80
2
CAUTION: Danger of crashing
When using the CPP head together with an MTC the travel range must be restricted in
addition. To do this, install the 2 extensions for the Y axis stop
("Adaption Stop Y Axis MTC" [03075963-xx]) at the location with the MTC. These are
included in the Head Reconfiguration Kit. 2
Standard Y stop
Y stop for MTC with CPP
Head Reconfiguration Kit 2 Assembly Instructions Head Reconfiguration Kit CPP for the SIPLACE X Series
Issue 03/2010 2.7 Installing the CPP Placement Head
81
2
– A docking frame of version -04 must not be reconfigured.
2
– When using the CPP head together with the MTC, the crash light barriers on the feeding axis
of the MTC must be fitted at the low position. Please refer to the Assembly Instructions "MTC2
on Component Trolley Docking Unit X-S" [00194725-xx] for further details.
– For CPP heads in the high position that are used in conjunction with an MTC the lowest pickup
height with respect to the top edge of the board is -1.5 mm when the shortest nozzle is used.
Any edges protruding the tray must also be observed.
2
CAUTION: Danger of crashing
When using the CPP head together with the MTC, the "notch socket" positioning aid at
the docking frame of the MTC must be replaced. Install the 2 "notch sockets" [03010773-
02] (height: 103 mm). These are included in the Head Reconfiguration Kit. 2
Notch socket MTC
(standard)