00197500-04_IM_Material_Manager_2.1_EN.pdf - 第41页
Setting Up a PC for the PDA and the 2D Scanner Configuring the 2D Scanner Installation Manual SIPLACE Material ManagerV2.1 41 Selecting interface Entering Wedge pa rameters
Setting Up a PC for the PDA and the 2D Scanner
Installing an Upgrade of the PDA Client Software
40 Installation Manual SIPLACE Material ManagerV2.1
4.3
4.3 Installing an Upgrade of the PDA Client Software
Installing an Upgrade of the PDA Client Software
If a new version of the PDA client software gets installed on the PC, the installation program detects
whether a previous version has already been installed.
In this case, the following message is displayed.
Previous version present
► Click on Yes to remove the previous and install the new version.
The following message is displayed on the PDA:
Previous version present
► Click on OK to remove the previous and install the new version.
4.4
4.4 Configuring the 2D Scanner
Configuring the 2D Scanner
In this section you find a short description of the software configuration of the PowerScan M8500 2D
scanner from the DATALOGIC company.
This 2D scanner is required to read the 2D barcodes that are located on the various material containers.
In the Material Manager, the scanner is used for the Identify Incoming Material function in the Material
Receipt area.
► Start the ALADDIN software.
► Configure the scanner and the cradle as displayed in the following dialogs.
Setting Up a PC for the PDA and the 2D Scanner
Configuring the 2D Scanner
Installation Manual SIPLACE Material ManagerV2.1 41
Selecting interface
Entering Wedge parameters
Setting Up a PC for the PDA and the 2D Scanner
Configuring the 2D Scanner
42 Installation Manual SIPLACE Material ManagerV2.1
Beeper settings
DATAMATRIX settings