OM-1352-003_w.pdf - 第50页

6-1 Tg1357-ID-SO 0703-003 6. Data 6.1 Pattern Program 6.1.1 Placement Feeder Location Data It must be speciﬁed on which feeder No. (Fdr . No.) of the feeder base the ﬂux dispensing unit should be installed. Rear Side of …

5-8

Tg1357-ID-SO

0703-003

[9] [Recog Dsp setup] Button

When this button is pressed, the following window opens, enabling the

operator to specify a graphic desplay mode for the recognized image,

depending on whether the results of a recognition operation are normal

or abnormal.

Fig.17 "Display Mode" Window

[Cross] :

When this is selected and the results of a

recognition operation are normal, a cross-

hair appears at the center of the recognized

object.

[Circle] :

When this is selected, a circle appears on

the recognized object.

[Outside] :

When selected, this displays the outline of

the recognized object.

[Noz Outside] :

When selected, this displays the vacuum

nozzle that was used to recognize a

component.

[Detect Pos] :

When selected, this displays the detection

position and area.

[Set Default] :

When pressed, this button sets the defaults.

When several display types (multiple selection possible) are selected

and the [OK] button is pressed, the speciﬁed types (modes) are saved.

When the [Cancel] button is pressed, the selection is canceled.

5.2 Component Recognition Test

6-1

Tg1357-ID-SO

0703-003

6. Data

6.1 Pattern Program

6.1.1 Placement Feeder Location Data

It must be speciﬁed on which feeder No. (Fdr. No.) of the feeder base the

ﬂux dispensing unit should be installed.

Rear Side of Machine

Front Side of Machine

Feeder Base #3

Feeder Base #4

Feeder Base #2

Feeder Base #1

Unit #4

Unit #3

Unit #2

Unit #1

Fig. 18 Positional Relation between Feeder Bases and Flux Dispensing Units

Note

Up to 4 ﬂux dispensing units can be installed on one feeder base.

6. Data

6-2

Tg1357-ID-SO

0703-003

Open the "Feeder Base #1" tab sheet in the "Placement Feeder Location" tab

sheet.

Press the icon ( ) and then icon ( ) to open the "Feeder Base" tab

sheet and edit the "Feeder Base" data.

Note

As for Feeder Bases #2 and #3, follow the same procedure to open the cor-

responding tab sheets.

[3]

[2]

[1]

Fig. 19 "Feeder Base #1" Tab Sheet

[1] Flux Unit Nos. 1 to 4

Reload Method

Select the ﬂux reload method from "Manual" and "Automatic".

Note

In this unit, select "Manual".

Reload Time [sec]

Set the ﬂux reload time period.

Memb. Thkns [mm]

Set the coating thickness.

Classiﬁcation

Set the ﬂux type used in the ﬂux dispensing unit.

No. of Rot. [rot.]

Specify the rotational speed of the drum (rotational disk).

Data Input Range: 0.5 to 5 [Rotations]

Dispensing Position X,Y[mm]

Set the dispensing position offset values.

6.1 Pattern Program