1_SME_DB_Feeder_User_Guide(Eng_Ver1.4).pdf - 第70页
3-12 SM-Series SME DB Tape Feeder User's Manual Figure3.15 SME 12~88mm Tape Feeder
3-11
Maintenance
3.2.8.1. Various joints and areas subject to friction
The following figure indicates the areas where friction occurs due to movement when
installing or operating the feeder. If noise generates or friction is felt significantly at an
indicated area, apply a small amount of grease to it.
In particular, if friction or noise occurs due to the movement of the tape guide or drain
gear, contact our C/S.
Memo The type of recommended grease for lubrication:
MICROLUBE GLY92 GREASE (MAKER : KLUBER)
Caution If the tape guide contacting the tape is stained with grease,
problems such as defective feeding accuracy and vinyl
curling may occur.
Figure3.14 SME 8mm/W4P1 feeder
3-12
SM-Series SME DB Tape Feeder User's Manual
Figure3.15 SME 12~88mm Tape Feeder
4-1
Trouble Shooting
Chapter4. Trouble Shooting
4.1. Problems and Measures
Problem Possible Cause Measures
It is not
possible to
push a
feeder in
since the
feeder is
stuck in a
feeder
base slot
Foreign materials exist in the
feeder base slot.
Remove the foreign materials.
Interference between neighboring
feeders.
When a part with a loosened
bolt is found, tighten it. If the
reel hanger is deformed, fix it.
If this is not possible, contact
our C/S.
Discharged tape is jammed
between feeders.
Check and take proper
measures.
A damaged location pin is stuck in
the pin hole of the feeder base.
When foreign materials are
present, remove them. If a
location pin is damaged,
contact our C/S company.
Since the pin hole of the feeder
base is damaged, the feeder
cannot be inserted.
Contact our C/S company.