CP643规格书.pdf - 第20页

9.2 Details of Options 9.2.1 Reference Pin Unit (1) This system uses pins to hold the PCB in position. It can also be used in combination with fiducial marks. (2) The following reference pins are available. • Diameter 3.…

100%1 / 33
– 16 –
CP-643E/643ME Specifications
Edition 3.0
9. Options
9.1 Classification by Installation Status
The optional features are classified into three categories depending on when they are
installed:
A : Options which are ordered along with the machine.
B : Options which can be installed on-site.
C : Options which can be purchased.
Item
Reference pin unit
PCB support
Nozzles (spare)
Support for thin PCBs
Tape feeders and bulk feeders
Feeder stand
Handy Terminal
Roller conveyor
HELPS
Other
No.
1
2
3
4
5
6
7
8
9
10
Category
B
B or C
C
A
C
C
C
A
A
Note
Under development
Under development
9.2 Details of Options
9.2.1 Reference Pin Unit
(1) This system uses pins to hold the PCB in position. It can also be used in
combination with fiducial marks.
(2) The following reference pins are available.
• Diameter 3.0 mm round or diamond shaped.
• Diameter 4.0 mm round or diamond shaped.
Note: The use of reference pins increases the PCB loading time by 0.3 seconds.
Contact Fuji if the reference pins are to be used with PCBs less than 1.0
mm in thickness.
9.2.2 PCB Support
(1) Back-up pins
It is possible to purchase further back-up pins to supplement the number
supplied with the CP-643E/643ME.
(2) Vacuum back-up pins
PCBs can be supported using vacuum pressure supplied through special
back-up pins. The vacuum back-up system comes with 10 vacuum back-up
pins. Extra pins can be purchased separately.
Note: The XY-table used with the vacuum back-up pins differs from the
standard XY-table. The standard back-up pins cannot be used with this
table. PCB loading time is lengthened by approximately one second when
using vacuum back-up pins. This may also vary depending on the
settings made for the speed of the XY-table.
– 17 –
CP-643E/643ME Specifications
Edition 3.0
(3) Shock free back-up plate
To reduce the amount of vibration during part placement, rubber blocks can
be placed under the PCB to absorb the impact of parts being mounted.
These blocks can be used with the standard XY-table back-up plate. The
blocks come with 20 mm segment slits so they can be easily split up and
arranged on the back-up plate as necessary.
9.2.3 Nozzles (Spare)
Order additional nozzles as necessary.
9.2.4 Support for Thin PCBs
Support for PCBs thinner than 0.5 mm (no thinner than 0.3 mm) is available.
R12-004
R12-007
R12-010
R12-013
M12-013
R12-018
R16-025
R16-037
Nozzle type
R20-025
M20-025
R20-037
S20-050
S22-050
B22-050
S22-070
B22-070
100
20
39.2
units: mm
PCB lower surface
is the reference.
– 18 –
CP-643E/643ME Specifications
Edition 3.0