卧式standard头部.pdf - 第33页
Page 31 V/S Standard Insertion Head Assembly T50090901 Rev . F This Document Supports Assembly 50090901 Rev. D 11. Click on Set to save the setting. 12. Loosen the three cap screws in the drive pulley then using the 7/16…
Page 30
T50090901 Rev. F V/S Standard Insertion Head Assembly
This Document Supports Assembly 50090901 Rev. D
The following message is displayed.
6. Click on Yes. This zeros all axes.
The following screen is displayed
7. Because the Head Drive axis is disabled, zero the head drive axis again
then actuate the -Jog 200 counts to move the tooling out of the way.
8. Insert the gauge pin in corresponding chain clips at the repair position
in the head chains.
9. In the Set Up Critical Axis Positions screen, click on the Head Chain
then Enable to enable the chain drive.
10. With the head chain zeroed, open the BEC arm then jog the head chain
positive until the gauge pin aligns with the right hand shear blade V
groove. Jog the head tooling down to move the V groove close to the
gauge pin.
CAUTION
To prevent damage to the head tooling, ensure that the tooling is fully
retracted before moving the head chain to remove the gauge pin.
Page 31
V/S Standard Insertion Head Assembly T50090901 Rev. F
This Document Supports Assembly 50090901 Rev. D
11. Click on Set to save the setting.
12. Loosen the three cap screws in the drive pulley then using the 7/16
wrench, turn the left hand chain shaft until the gauge pin aligns with
the V groove in the left hand tooling.
Repair Position
13. Tighten the three cap screws in the drive pulley then click on Set to
save the setting.
14. Close the BEC arm and remove the gauge pin from the head chain.
15. If no additional set ups are to be performed, exit out of the IM Diag-
nostics function.
End of procedure.
Part Missing Detector Adjustment
Purpose:
To set the detector sensitivity to properly detect missing parts.
Procedure:
1. Palm the machine down as detailed in the Operation Reference manual.
2. Refer to the sensor illustration for set up.
Page 32
T50090901 Rev. F V/S Standard Insertion Head Assembly
This Document Supports Assembly 50090901 Rev. D
2.1 Place the output timer selector switch to the Output timer OFF
position.
SENS
MAX
FINE
TURBO
OFF. D
ON. D
OFF
D. ON
L. ON
FS-M1
Operation indicator (Red LED):
Lights when the control output is activated.
Indicator:
Indicates the current position of the sensitivity
adjustment trimmer.
Stable operation indicator (Green LED):
Lights when a sufficient light quantity is received.
Sensitivity adjustment trimmer:
8-turn trimmer. Turning the trimmer clockwise
increases the sensitivity.
FINE/TURBO selector switch
FINE: Ultra-high accuracy
TURBO: Ultra-long detecting distance
Output timer selector switch
Output OFF-delay: 40 ms
Output ON-delay: 40 ms
Output timer OFF
.Output selector switch
DARK ON
LIGHT ON
4-conductor cable
2.2 Place the FINE/TURBO selector switch to the FINE position.
2.3 Place the Output selector switch to the LIGHT ON position.
2.4 Set the sensitivity to the minimum. (Ensure that the operation
indicator (red LED) extinguishes. If possible, keep the pointer
within the transparent window range.)