卧式standard头部.pdf - 第76页
Page 74 T50090901 Rev . F V/S Standard Insertion Head Assembly This Document Supports Assembly 50090901 Rev. D (hi g h lo be on cam - bot h sid es ) (outside circumf erence bet ween ar ro w s) Interv a l 1, 2 , 3 Interv …
Page 73
V/S Standard Insertion Head Assembly T50090901 Rev. F
This Document Supports Assembly 50090901 Rev. D
12,000,000 Cycles (Maintenance Interval 3)
Check: Perform Maintenance:
1. Clean and lubricate the insertion head tooling
housings with Kluber Syntheso D32.
36,000,000 Cycles (Maintenance Interval 4)
Check: Perform Maintenance:
1. Inspect all belts for wear and correct 1. Adjust and replace as necessary.
tension setting.
2. Remove, disassemble centering housing 2. Clean and lubricate the pivot points with a light
assembly. coat of Magnalube grease.
144,000,000 Cycles (Maintenance Interval 6)
Check: Perform Maintenance:
1. Lubricate the grease fittings with super blue grease.
2. Remove the lower shafts and sprockets. 2. Clean and lubricate the thrust bearings with
Magnalube grease.
