Micron Technical Reference V9 Volume 1.pdf - 第109页

PRINTER OVERVIEW MODULE OVERVIEWS Chapter Issue 11, Jan 17 Technical Reference Manual 4.15 Pneumatics Module The function of the pneumatics mod ule is to supply regulated air pressure to the pneumatic devices throughout …

100%1 / 290
PRINTER OVERVIEW
MODULE OVERVIEWS
4.14 Technical Reference Manual Chapter Issue 11, Jan 17
Print Carriage
Module
The print carriage module is the vehicle that transports the following:
• Squeegee/ProFlow Module
• Paste Dispenser Module
• Screen Change Module
Paste Dispenser
Module
The function of the paste dispenser module option is to apply a precise amount
of solder paste onto the print screen, the frequency is fully programmable in
software.
Figure 4-17 Print Carriage - Paste Dispenser
Paste Dispenser
Print Carriage
PRINTER OVERVIEW
MODULE OVERVIEWS
Chapter Issue 11, Jan 17 Technical Reference Manual 4.15
Pneumatics
Module
The function of the pneumatics module is to supply regulated air pressure to the
pneumatic devices throughout the printer. The air supply is routed to the
required pneumatic device via an electrically operated solenoid valve controlled
by the printer control system.
There are two banks of pneumatic solenoids, one located on the rear frame of
the printer and the other located on the print carriage.
Squeegee Module The function of the squeegee module is to apply the print material through the
stencil image onto the board in a controlled manner. Squeegee height and
downward pressure is monitored during the print stroke to optimize the print
quality.
ProFlow Module The ProFlow module is an optional self contained paste transfer unit, employed
to apply print material directly to a stencil, alleviating the need for squeegees
and the paste dispenser.
Figure 4-18 Pneumatics - Squeegee - ProFlow
Squeegees
ProFlow
Pneumatics
PRINTER OVERVIEW
MODULE OVERVIEWS
4.16 Technical Reference Manual Chapter Issue 11, Jan 17
Foreign Machine
Interface (FMI)
Module
The FMI provides a communications link between upline/downline machines
and the DEK printer.
The FMI pod, fitted to the rear of the printer, is used to communicate with upline/
downline machines using SMEMA, Fuji or Panasonic interfaces.
NOTE
Type 4 printers, the FMI pod is accessed from the front of the printer.
The Multi-Interface Unit (MIU), fitted inside the front cover of the printer, is used
to communicate with upline/downline machines using all other protocols.
Figure 4-19 Foreign Machine Interface