PatternPro Variable Pitch Guns.pdf - 第15页

11 P/N 1048257_03  2018 Nordson Corporation PatternPro Edition 02/18 Description The PatternPro pneumatic applicator has a unique rotating disk design (twist adapter), which enables an applicator module to be pivoted fo…

100%1 / 54
10
P/N 1048257_03
2018 Nordson Corporation
PatternPro
Edition 02/18
First Aid
If molten hot melt comes in contact with your skin:
1. Do NOT attempt to remove the molten hot melt from your skin.
2. Immediately soak the affected area in clean, cold water until the hot melt
has cooled.
3. Do NOT attempt to remove the solidified hot melt from your skin.
4. In case of severe burns, treat for shock.
5. Seek expert medical attention immediately. Give the MSDS for the hot
melt to the medical personnel providing treatment.
Safety Labels and Tags
Figure 1 illustrates the location of the product safety labels affixed to the
equipment. Table 2 provides an illustration of the hazard identification
symbols that appear on each safety label, the meaning of the symbol, or the
exact wording of any safety message. Occasionally, the safety labels may be
located elsewhere on the applicator.
2
1
Fig. 1 Safety labels
Table 2 Safety Labels
Item
Part Description
1. N/A
WARNING: Hot surface! Before touching the applicator body, allow the
applicator to cool, or wear heat‐protective gloves. Failure to allow the
applicator body to cool or to wear heat‐protective gloves may cause
personal injury.
2. N/A
WARNING: Risk of electrical shock. Failure to observe may result in
personal injury, death, or equipment damage.
11
P/N 1048257_03
2018 Nordson Corporation
PatternPro
Edition 02/18
Description
The PatternPro pneumatic applicator has a unique rotating disk design (twist
adapter), which enables an applicator module to be pivoted for application of
variable pitch patterns.
The applicator is designed to be configured with the following components:
Applicator modules
Nozzles
Solenoid valves
Cordsets
Glue connector / Filter
Refer to Figure 3 for applicator Configuration Options and Table 3 for
Component Specifications.
Intended Uses
PatternPro applicators are designed for use
in industrial applications that require the deposition of a precise
application of hot melt adhesive onto a moving substrate
with an electrically controlled solenoid valve
with melters, hoses, and pattern controllers designed and manufactured
by Nordson Corporation
NOTE: The applicator should only be connected to approved devices. Use
only new Nordson replacement parts or approved factory refurbished parts.
12
P/N 1048257_03
2018 Nordson Corporation
PatternPro
Edition 02/18
Key Components
4
1
5
8
6
237
Fig. 2 Key Components of the applicator
1 Applicator Module
2 Nozzle
3 Rotating disk
4 Cordset
5 Solenoid valve
6 Tube to Solenoid valve
7 Applicator body
8 Mounting bracket
Note: Hose connector is located on the back of the applicator.