00197787-02_SI_SIPLACE_HeadVerification_EN.pdf - 第33页
5 Online head verification workflow 5.5 Available measurements for TH Software Manual SIPLACE Head Verification 03/2018 33 5.5 Available measurements for TH Required tools ● 1x Nozzle 517 [03012042-xx] ● 1x Nozzle 504 – …
5 Online head verification workflow
5.4 Available measurements for CPP
32 Software Manual SIPLACE Head Verification 03/2018
5.4 Available measurements for CPP
Required tools
●
1x calibration part version 3 [03010565-xx]
●
12x nozzle 2069 [03094135-xx]
●
12x nozzle 2057 [03070280-xx]
●
12x magazine for 2xxx nozzle [03066107-xx]
Verification workflow
NOTICE
Head Verification versus Test Bench Inspection mode
The Head Verification mode provides a fast verification with the main focus on the Z-axis
and the vacuum system. All red framed tasks are not shown.
The Test Bench Inspection mode includes all available tasks as shown in figure "Available
measurements for CPP (Test Bench Inspection mode)" [}32].
Fig.30: Available measurements for CPP (Test Bench Inspection mode)
1 CS-Sensor voltage and z-heights
See 6.5 "CS Sensor voltage and z-heights" [}44]
2 Dp- / Z-Positioning
See 6.9 "Dp- / Z-Positioning" [}50]
3 Holding circuit (sealed nozzles)
See 6.17 "Holding circuit (sealed nozzles)" [}68]
4 Nozzle spring
See 6.18 "Nozzle spring" [}70]
5 Z-axis movement
See 6.22 "Z-axis movement" [}81]
6 Air & vacuum with head sensors
See 6.2 "Air & vacuum with head sensor" [}37]
7 DP rotation test
See 6.8 "DP rotation test" [}48]
8 Segment offset up & down (fast)
See 6.19 "Segment offset up & down (fast)" [}72]
9 Head Endurance Run 01005
See 6.14 "Head endurance run 01005" [}60]
10 Head Endurance Run LS
See 6.16 "Head endurance run LS" [}65]
5 Online head verification workflow
5.5 Available measurements for TH
Software Manual SIPLACE Head Verification 03/2018 33
5.5 Available measurements for TH
Required tools
●
1x Nozzle 517 [03012042-xx]
●
1x Nozzle 504
– Adapter for 9xx nozzle [00330027-xx]
– Adapter nozzle interface [03011583-xx]
– Nozzle 904 [00322602-xx]
Verification workflow
Fig.31: Available measurements for TH
1 Head info
2 DP positioning time
See 6.7 "DP positioning time" [}47]
3 Z-Axis travel distance
See 6.23 "Z-Axis travel distance" [}83]
4 Z positioning time
See 6.25 "Z positioning time" [}87]
5 Air & vacuum checks
See 6.1 "Air & vacuum checks" [}35]
6 Head endurance run 2N
See 6.15 "Head endurance run 2N" [}63]
5 Online head verification workflow
5.5 Available measurements for TH
34 Software Manual SIPLACE Head Verification 03/2018