00197787-02_SI_SIPLACE_HeadVerification_EN.pdf - 第52页

6 Description of the test results 6.10 Filter Disc 52 Software Manual SIPLACE Head Verification 03/2018 6.10 Filter Disc 6.10.1 Measurement principle The Filter disk measurement checks the filter discs on the C&P20A…

6 Description of the test results

6.9 Dp- / Z-Positioning

Software Manual SIPLACE Head Verification 03/2018 51

6.9.3 Interpretation of the results obtained

‘ZVariation’ and ‘CSVariation’ error for all segments

Cause Solution

Mechanical damage to Z-axis linear guide ► Replace the Z-axis drive.

Z-axis read unit dirty ► Clean the Z-axis read unit.

‘ZVariation’ error for individual segments

Cause Solution

Mechanical damage to Z-axis linear guide ► Replace the Z-axis drive.

Z-axis read unit dirty ► Clean the Z-axis read unit.

Linear guide of segment damaged ► Replace the linear guide of this segment.

Z-axis down light barrier of this segment pol-

luted

► Clean the light barrier and switching ring

through service gap.

‘CSVariation’ error for all segments

Cause Solution

Component sensor polluted ► Clean the prism at the component sensor.

Component sensor damaged ► Replace the component sensor.

‘CSVariation’ error for individual segments

Cause Solution

Linear guide of segment damaged ► Replace the linear guide.

Bad nozzle seating ► Check the nozzle interface and replace if

necessary.

6 Description of the test results

6.10 Filter Disc

52 Software Manual SIPLACE Head Verification 03/2018

6.10 Filter Disc

6.10.1 Measurement principle

The Filter disk measurement checks the filter discs on the C&P20A head segments for pollution

and disc seal tightness.

During the measurement, all nozzles are returned to the nozzle changer before an air blast of

400mbar is applied to each segment to blow off loosely fitted or damaged filter discs and to clean

the remaining filter discs. Finally, all segments are visually checked for missing filter discs. The

segments to which a filter disc is still attached are visually checked again for contamination.

6.10.2 Measurement result

Fig.42: Result view – Filter disc

1 Measured Segment

2 Filter disc OK provides the status of the filter disk verification:

●

‘0’ indicates an error: The filter disc is either missing or the existing filter disc is pol-

luted.

●

‘1’ indicates that no pollution was detected on the filter disc

3 Result view indicating if the values are within (green tick) or outside (red cross) the limits.

4 Vision image showing the filter disk, captured by the component camera.

6 Description of the test results

6.10 Filter Disc

Software Manual SIPLACE Head Verification 03/2018 53

6.10.3 Interpretation of the results obtained

‘Filter disk OK’ error for all segments

Cause Solution

Holding circuit clogged ► Clean the holding circuit or replace it.

Filter disks clogged ► Replace the filter disks.

‘Filter disk OK’ error for individual segments

Cause Solution

Filter disks clogged ► Replace the filter disk.