444CEMM1.pdf - 第131页

Page 1-69 REGULAR MAINTENANCE 1 Check Every 560 Hours (Once a Month) 3. Discharge the air . Close the main air valve. Pull up the regulator knob, and turn it to the left until it stops. Make sure the exhaust sound disapp…

100%1 / 158
Page 1-68
444C-E-MMA01-A09-04
Check Every 560 Hours (Once a Month)
1-5-2 Cleaning and Lubricating the Cutting Unit
For D/DU, the cutting unit is an option. The cutter consists of the fixed blade and movable blade.
∗ For DU/DHU specifications, it is necessary to remove the feeder base cover for the maintenance.
“1-2-3 Setting and Removing the Feeder Base Cover (Only for DU/DHU Specifications)”
Procedures of CM201-D/DU and CM202-D/DU
1. Turn OFF the power.
∗ Lock the main switch. A worker should carry
the key. (DU/DHU only)
2. Open the cover at the lower right of
the machine rear side.
∗ Remove the screw with the Philips driver.
M60E
DO NOT TOUCH THE CUTTER BLADE WITH YOUR FINGERS.
The edge is so sharp that you may injure yourself.
CAUTION
Tools Philips driver, wrench, and cloth Required time 30 minutes
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
4U4C-AB00
AR
BR
444C-401P
To the next page
444C-457E
Page 1-69
REGULAR
MAINTENANCE
1
Check Every 560 Hours (Once a Month)
3. Discharge the air.
Close the main air valve.
Pull up the regulator knob, and turn it to the left
until it stops.
Make sure the exhaust sound disappears and
the gauge shows 0 MPa.
Lock the valve lever. A worker should carry the
key. (DU/DHU only)
4. Open the safety cover.
5. Draw the tape feeder table.
6. Remove the tape chute.
∗ Loosen the bolt set to the inner side.
To the next page
444C-E-MMA01-A09-03
Bolt
444C-464P
444C-465P
Tape chute
444C-425E
Valve
444C-402P
1
2
3
4
1
2
3
Page 1-70
444C-E-MMA01-A09-04
Check Every 560 Hours (Once a Month)
7. Apply the grease to the fulcrum part
of the movable blades.
[Grease : SHELL STAMINA GREASE RL2]
∗ Ensure that the blade is not broken.
8. Set the tape chute.
∗ After that, carry out these steps in the reverse
order to prepare for supplying the power.
Procedure of CM201-DH and CM202-DH/DHU/DK
1. Turn OFF the power.
2. Open the safety cover.
3. Lubricate through the grease nipple
for the cutting unit.
[Grease : SHELL STAMINA GREASE RL2]
444C-467P
Fixed blade
Movable blade
444C-426E
Fulcrum part
Fulcrum part
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
444C-505P
444C-504P
Grease nipple