444CEMM1.pdf - 第138页

Page 1-76 444C-E-MMA01-A09-07 1-7 Check Every 6000 Hours (Once a Y ear) 1-7-1 Exchanging the Cutter Blade The fixed and the movable blade mounted in the cutting unit need to be replaced as consumable parts if they are wo…

Page 1-75

REGULAR

MAINTENANCE

444C-E-MMA01-A09-04

Check Every 3000 Hours (Once Six Months)

2. Exchanging the board transfer roller.

Hold the nut on the rear side and exchange the board transfer roller of the board conveyor.

1. Remove the board transfer roller

using a hexagon wrench.

2. Set the new board transfer roller.

3. Setting the board transfer belt

1. Check the transfer direction of the

belt.

∗ Fit the arrow direction printed on the belt to the

transfer direction.

2. Insert the belt into the gap between

the roller and the guide.

3. Put the belt to the driving pulley and

the tension pulley.

4. Check the belt tension.

For checking and adjusting the tension:

“1-4-5 Checking and Lubricating the Board

Conveyor”

Transfer direction

Arrow

3Y3C-082P

443C-328E

∗∗

∗ This picture shows the one for CM201/202-DH.

Page 1-76

444C-E-MMA01-A09-07

1-7 Check Every 6000 Hours (Once a Year)

1-7-1 Exchanging the Cutter Blade

The fixed and the movable blade mounted in the cutting unit need to be replaced as consumable

parts if they are worn because of the cutting of dropped chips. (For D/DU, the cutting unit is an

option.)

∗ For DU/DHU specifications, it is necessary to remove the feeder base cover for the maintenance.

“1-2-3 Setting and Removing the Feeder Base Cover (Only for DU/DHU Specifications)”

1. Press

Machine

adjust

2. Press Output check .

M60E

DO NOT TOUCH THE CUTTER BLADE WITH YOUR FINGERS.

The edge is so sharp that you may injure yourself.

CAUTION

Tools Philips driver and allen wrench Required time 30 minutes

To the next page

M106E

BE SURE TO RELEASE THE AIR PRESSURE INSIDE THE MACHINE WHEN

REPLACING THE CUTTER.

You may be injured if the cutter is moved.

CAUTION

Page 1-77

REGULAR

MAINTENANCE

444C-E-MMA01-A09-05

Check Every 6000 Hours (Once a Year)

3. Press Address .

4. Display “63. AstFront tape cutter

Open”, and turn it ON.

∗ If the cover of the cutter parts is not closed, it is

impossible to operate. (No.64 should be OFF)

5. Release the air pressure inside the

machine.

Close the main air valve.

Pull up the regulator knob, and turn it to the left

until it stops.

Make sure the exhaust sound disappears and

the gauge shows 0 MPa.

Lock the valve lever. A worker should carry the

key. (DU/DHU only)

4H4C-513P

444C-EEn-MaOc-015

To the next page