4OM-1064-001.pdf - 第32页
1-22 Air Filters Cleaning (1) Remove the air filter . Align the mark with the release position by pressing and turning the button at the same time. Then, draw the outer case downward to remove. Remove the inner air filte…
1-210004-002 Tg0249-PM-MM
Fig. 1.23 Clamp Sections of Tray Traverse
Cam Follower
Cleaning and Lubrication (DE1)
(1) Wipe off old grease with an oiled
rag.
Note: Take care not to leave
any waste thread.
(2) Apply new grease by hand or with
a brush.
Note: For the lubrication
procedure, refer to
“10.2 Traverse Clamp
Section”.
Large Linear Guide
Cleaning and Lubrication (DE1)
(1) Wipe off old grease with an oiled
rag.
Note: Take care not to leave
any waste thread.
(2) Lubricate the 2 nipples with new
grease from a grease gun.
Notes: (a) For the lubrication
procedure, refer to
“10.2 Traverse
Clamp Section”.
(b) The attachments to
be used are U type
and N type.
Small Linear Guide
Cleaning and Lubrication (DE1)
(1) Wipe off old grease with an oiled
rag.
Note: Take care not to leave
any waste thread.
(2) Apply new grease by hand or with
a brush.
Note: For the lubrication
procedure, refer to
“10.2 Traverse Clamp
Section”.
Beam A Side
Beam B Side
Nipple
Nipple
Nipple
Belt
U Type
N Type
7. Maintenance (Every 3 Months after Initial Maintenance in 1 Month)
1-22
Air Filters
Cleaning
(1) Remove the air filter.
Align the mark with the release position by pressing
and turning the button at the same time. Then, draw the
outer case downward to remove. Remove the inner air
filter by turning it in the direction of Arrow A.
(2) Blow off dust with compressed air.
(3) Mount the air filter.
Mount the air filter turning it in the direction of Ar-
row B.
Mount the outer case and at the same time press and
turn the button to align the mark with the locking
position.
Button
Lock
Unlock
B
A
Table 1.8
8. Maintenance (Every 3 Months)
0004-002 Tg0249-PM-MM
8. Maintenance (Every 3 Months)
Fig.1.24 Air Regulator
Maintenance Spots Check
Name
Fig.
No.
Description Grease
Cleaning
Tools,
Nozzles, etc.
Air Regulator Air Filters 1.24 Cleaning Air Gun
Vacuum Pressure
System
Aggregated Vacuum
Filter
1.25 Cleaning Air Gun
Control Box Dust Filter 1.26 Cleaning Vacuum
Cleaner
Beam A side
1-230004-002 Tg0249-PM-MM
8. Maintenance (Every 3 Months)
Fig. 1.26 Control Box
Dust Filter
Cleaning
(1) After removing the setscrews,
draw it out, holding the knobs on
the right and left sides.
(2) Clean dirt and dust with a vacuum
cleaner.
Fig. 1.25 Vacuum Pressure System
Filter Case
C
Aggregated Vacuum Filter
Cleaning
(1) Remove the filter case by turn-
ing in the direction of Arrow C
and remove the inner filter.
(2) Blow off dust with compressed air.
Beam B side
CAUTION
Use protective devices to avoid any accident which
may be caused due to the tight work space.
Unit : mm
Note: The dimensions in the figures
are design values.
Knob
Setscrew