YSM10_Mainte_E.pdf - 第88页
3-21 3 Periodic maintenance items 3.3 Base T his machine is equipped with the air intake fan filters (2 in total: 1 each for left and right on the front of the machine) to prev ent the heat generated while mo ving axes. …
3-20
3
Periodic maintenance items
4
Apply the new grease.
Apply as much as 2 cm of new grease to
your finger. Apply it equally on the surface
of the ball screws and the ball guides and
also into its grooves.
53329-KMG-00
5
Spread the grease.
1. Close the machine safety cover and
cancel the emergency stop.
2. The PU-axis moves down by pressing the
[Push Up] button again on the [Unit] -
[Conveyor] tab screen.
3. Raise the PU-axis as the board thickness
of 0.1 mm by pressing the [Push Up]
button again.
4. Repeat 2 and 3 several times.
6
Wipe away excess grease.
e
1. Press the emergency stop button to open
the machine safety cover.
2. Wipe all excess grease from the ball
screw and the ball guide end faces.
Step 4
Applying the grease
Grease
3-21
3
Periodic maintenance items
3.3 Base
This machine is equipped with the air intake fan filters (2 in total: 1 each for left and right on the front of the
machine) to prevent the heat generated while moving axes.
If the filters are not cleaned properly, the temperature inside the machine may rise due to filter clogging. Clean
the filters to prevent lowering of the machine function or shortening of the service life. As the filter is cleaned
after detaching the fan unit, power off the machine when cleaning the filter.
3.3.1 Cleaning the air intake filter for machine front side
1
Power off the machine.
2
Detach the fan unit.
1. Loosen 4 mounting screws with a phillips
screwdriver to detach the fan unit. It is
not necessary to remove the screws.
2. Disconnect the fan wiring connectors.
53330-KMG-00
3
Pull out the filter.
Remove the fan mounting nuts with a
wrench (7).
53331-KMG-00
4
Clean the filters.
Suck both surfaces of the filter with a
vacuum cleaner or vacuum tool to remove
dust.
c
CAUTION
If the filters are used while they are damp, the dust
combines with moisture and causes clogging. Since it is
enough to clean the filters with a vacuum cleaner, do
not wash the filters with water.
n
NOTE
If dust cannot be removed or the filter has worn out,
replace the filter with a new one.
5
Return the filter to the original
position.
Return the filter to the fan unit.
6
Return the fan unit to the original
position.
1. Reconnect the fan wiring connectors.
2. Return the fan unit to the original
position.
c
CAUTION
Make sure not to catch wires.
Detaching the fan unit
Step 2
Fan unit
Phillips screwdriver
Fan wiring connectors
Detaching the filter
Step 3
Filter
Wrench (7)
Fan mounting nut
3-22
3
Periodic maintenance items
n
Simple cleaning of air intake filter
The periodic filter cleaning procedure is described on the previous pages. The simple cleaning of air intake filter is also
available with a household vacuum cleaner. Remove dust over the filter cover.
c
CAUTION
Do not clean the air intake filter during the automatic operation.
Simple cleaning of air intake filter
Household vacuum cleaner
53363-KMG-00