FlexSeam Dispensing System Customer Product Manual.pdf - 第17页

Flexseam Dispensing System 13 Part 1127900_01 E 2019 Nordson Corporation Description This manual describes the installation and use of the Flexseam dispensing system. When necessary, the reader is referred to the documen…

Flexseam Dispensing System

Part 1127900_01

E 2019 Nordson Corporation

Safety Labels and Tags

Figure 1 illustrates the location of the product safety labels and tags affixed to

the equipment. Table 2 provides an illustration of the hazard identification

symbols that appear on each safety label and tag, the meaning of the

symbol, or the exact wording of any safety message.

Figure 1 Safety labels and tags

Table 2 Safety Labels and Tags

Item Part Description

- - - - - -

WARNING: Hot Surface! Do not touch.

2. - - - - - -

WARNING! Risk of electrical shock. Failure to observe may result in

personal injury, death, or equipment damage.

Flexseam Dispensing System

Part 1127900_01

E 2019 Nordson Corporation

Description

This manual describes the installation and use of the Flexseam dispensing

system. When necessary, the reader is referred to the documentation

supplied with other Nordson products or products supplied by third parties.

The Flexseam dispensing system liquifies solid‐form polyurethane reactive

(PUR) hot melt adhesive contained in 300‐cc cartridges and maintains the

adhesive at the desired temperature. When the system is activated, it uses

compressed air to dispense a row of adhesive beads onto the surface

(usually fabric) of a product.

See Figure 2. The system includes:

S The Flexseam controller

S The Flexseam applicator

S The four‐axis robot with vision detection (camera) and feedback

system

(if applicable—other robots are available)

Figure 2 Flexseam dispensing system components

1. Flexseam controller 2. Flexseam applicator 3. Robot

Flexseam Dispensing System

Part 1127900_01

E 2019 Nordson Corporation

Intended Use

Flexseam Series dispensing systems are specifically designed to:

S Melt and pump solid-form PUR hot melt adhesives contained in

cartridges that are engineered to be liquified and extruded at

temperatures below 160 ºC(320 ºF), and the nozzle temperature is

below 200 ºC (392ºF).

NOTE: This temperature setting is lower than the cartridge melt and

nozzle temperature limit.

S Be used with compatible equipment manufactured by Nordson

Corporation

S Be used in non‐explosive environments

The Flexseam dispensing system is virtually complete, but is intended to be

incorporated into machinery or assemblies by an integrator. The equipment

must not be placed into use in a member state of the European Union until

the parent machinery or assemblies have been declared by the integrator to

be in conformity with the applicable directives of the European Commission.

Limitations of Use

Use Flexseam Series dispensing systems only for the purpose for which they

are designed. Flexseam dispensing systems should not be used:

S To melt or pump any material that creates a health or safety hazard

when heated

S In environments that will require the system to be cleaned using a

water wash or spray

Additional Limitations of Using PUR Adhesives

When the maximum level of harmful substance concentration is exceeded,

use a gas mask and air purifying equipment.