FlexSeam Dispensing System Customer Product Manual.pdf - 第19页
Flexseam Dispensing System 15 Part 1127900_01 E 2019 Nordson Corporation Unit Identification See Figure 3. You will need the model and part number of the applicator when requesting service or ordering spare parts and opt…
Flexseam Dispensing System
14
Part 1127900_01
E 2019 Nordson Corporation
Intended Use
Flexseam Series dispensing systems are specifically designed to:
S Melt and pump solid-form PUR hot melt adhesives contained in
cartridges that are engineered to be liquified and extruded at
temperatures below 160 ºC(320 ºF), and the nozzle temperature is
below 200 ºC (392ºF).
NOTE: This temperature setting is lower than the cartridge melt and
nozzle temperature limit.
S Be used with compatible equipment manufactured by Nordson
Corporation
S Be used in non‐explosive environments
The Flexseam dispensing system is virtually complete, but is intended to be
incorporated into machinery or assemblies by an integrator. The equipment
must not be placed into use in a member state of the European Union until
the parent machinery or assemblies have been declared by the integrator to
be in conformity with the applicable directives of the European Commission.
Limitations of Use
Use Flexseam Series dispensing systems only for the purpose for which they
are designed. Flexseam dispensing systems should not be used:
S To melt or pump any material that creates a health or safety hazard
when heated
S In environments that will require the system to be cleaned using a
water wash or spray
Additional Limitations of Using PUR Adhesives
When the maximum level of harmful substance concentration is exceeded,
use a gas mask and air purifying equipment.
Flexseam Dispensing System
15
Part 1127900_01
E 2019 Nordson Corporation
Unit Identification
See Figure 3. You will need the model and part number of the applicator
when requesting service or ordering spare parts and optional equipment. The
applicator model and part number are indicated on the equipment
identification plate.
Figure 3 Applicator equipment identification plate
Flexseam Dispensing System
16
Part 1127900_01
E 2019 Nordson Corporation
Key Components
Figures 4 provides the name and location of key system components.
9
7
10
11
Slot Coating applicator
Jetting applicator
12
13
Figure 4 Flexseam applicator key components
1. Air cap
2. Solenoid valve
3. Heater
4. Nozzle plate (slot coating)
5. Shave lip
6. Nozzle lip
7. Module
8. RTD
9. Cartridge body
10. Cover and bracket
11. Robot
12. Nozzle plate (jetting)
13. Nozzle (jetting)