2OM-1751-003w_G5S.pdf - 第141页
2OM-1751 2-19 1303-001 Front Right : The placement coordinate reference is based on the front right side and specied as follows. X + Y + Placement Coordinate Reference (No) PCB F2B13 Rear Right : The placement coordinat…
2OM-1751
2-181303-001
(B01_04)
PCB Positioning Reference
Set the PCB positioning reference in this text box. The reference must be
specied according to the input and output machines.
Rear Left
: The placement coordinate reference is based on the rear left
side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B11
Front Left
: The placement coordinate reference is based on the front left
side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B12
3.2 PCB
2OM-1751
2-191303-001
Front Right
: The placement coordinate reference is based on the front
right side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B13
Rear Right
: The placement coordinate reference is based on the rear
right side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B14
Notice
Be sure to set the same reference as the input and output machines.
If a reference different from the input and output machines is specied,
PCBs cannot be produced correctly.
Note
When a different reference is specied in the pattern program and the program
is to be used for this machine, be sure to change the reference of this machine to
the different one.
3.2 PCB
2OM-1751
2-201303-001
(B01_05)
Comp library placement offset
"Enable" or "Disable" for the use of the Component Library Placement
Offset Function, is set in this data box.
When "Enable" is set, the system is operated based on the values set in the
component library.
(B01_06)
PCB Warpage [mm]
Specify the maximum value of the PCB upward warpage.
Notice
Whenever the data is changed, be sure to optimize the data.
•
Data Input Range
0.000 to 3.000
(B01_07)
Lot Name
The lot name of the pattern program is set in this text box.
Max. 39 characters are used for the setting.
The available characters are half-width alphabetical and numerical characters
and symbols.
Note
Even when this comment is not set, it does not inuence on the machine
performance.
(B01_08)
Comment 1 and Comment 2
Comments on the pattern program can be specied in these text boxes.
Up to 32 characters (alphanumerics and marks) can be used.
Note
The performance of the machine is not affected by these comments. In
other words, it has nothing to do with or without these comments.
3.2 PCB