2OM-1751-003w_G5S.pdf - 第187页

2OM-1751 2-65 (G04_02) X [mm] and Y [mm] Set the coordinates of each pattern origin (O01 through On) based on the placement coordinate reference (N0). A pattern origin refers to the reference coordinates of a repetitive …

100%1 / 380
2OM-1751
2-64
(G04) O-Data
When the [O-Data] button is pressed in the "Placement" window, the
following tab sheet appears.
F2B53
(G04_01)
Ono.
Shown are the step Nos. of the placement data (O).
These step Nos. are regarded as repetitive pattern Nos. Parameters must be
entered in each line (pattern).
O-No.1
O-No.2
O-No.3
O-No.4
Pattern 4
Pattern 2 Pattern 1
Pattern 3
Example of Repetitive Pattern Program F2B54
1303-001
3.7 Placement
Graphic
Development
2OM-1751
2-65
(G04_02)
X [mm] and Y [mm]
Set the coordinates of each pattern origin (O01 through On) based on the
placement coordinate reference (N0). A pattern origin refers to the reference
coordinates of a repetitive pattern.
The pattern origins (coordinate reference of repetitive patterns) must
be determined, regarding the "Z=theta [deg]" data as "0°" (described
in "G04_03") and located at corners on the same side as the placement
coordinate reference (N0).
N
0
:
The center of
is the placement coordinate reference.
O
01
:
Pattern Origin of Pattern 1
O
02
:
Pattern Origin of Pattern 2
O
03
:
Pattern Origin of Pattern 3
O
04
:
Pattern Origin of Pattern 4
O04
O03
O02
O01
X
Y
Placement Coordinate
Reference (No)
Component
Pattern 4 Pattern 3
Pattern 2 Pattern 1
Example of Repetitive Patterns F2B55
1303-001
3.7 Placement
2OM-1751
2-66
(G04_03)
Z=theta [deg]
Set an angle of each pattern. Keep the angle of the reference pattern as "0
deg".
In the gure below, "Pattern 1" is regarded as a reference one.
N
0
:
The center of
is the placement coordinate reference.
O
01
:
Pattern Origin of Pattern 1
O
02
:
Pattern Origin of Pattern 2
O
03
:
Pattern Origin of Pattern 3
O
04
:
Pattern Origin of Pattern 4
Pattern 1 :
0 deg
Pattern 2 :
90 deg
Pattern 3 :
180 deg
Pattern 4 :
270 deg
X
O
03
O02
O01
O04
Y
Placement Coordinate
Reference (No)
Component
Pattern 4
Pattern 3
Pattern 2
Pattern 1
Example of Repetitive Patterns F2B56
Note
A numerical value must be entered in increments of 90 deg. Otherwise, an
error will occur.
1303-001
3.7 Placement