2OM-1751-003w_G5S.pdf - 第356页
2OM-1751 6-84 (7) When the mold teaching is completed, check the data and press the [Fixed] button. (If the component size or angle is not correct, press the [Modify] button to correct the graphic image.) Note T o turn t…
2OM-1751
6-83
(5) Press the [Teaching] button to select the teaching method.
Note
When the [Editing] button has been selected, the editing operation is
performed based on the sample data. Press the [Complete] button to return
to the component library teaching window.
F2F90
(6) Press the [Teach] button to start the mold teaching operation.
Note
Make sure that the component image is within the frame with dot lines. If
the component is out of the frame, adjust it again.
F2F91
1303-001
7.3 "COMP RCG" Test Window
2OM-1751
6-84
(7) When the mold teaching is completed, check the data and press the [Fixed]
button.
(If the component size or angle is not correct, press the [Modify] button to
correct the graphic image.)
Note
To turn the graphic, click the coordinate graphic and drag either one of the
arrow ends.
F2F92
(8) Press the [Teach] button to start the corner and edge teaching operation.
F2F93
1303-001
7.3 "COMP RCG" Test Window
2OM-1751
6-85
(9) When the corner and edge teaching operation is completed, check the data
and press the [Fixed] button.
F2F94
(9-1) Press the [Modify] button.
(The following "Data Edit" window appears. The data parameters can be
corrected for each corner data or edge data item.)
F2F95
Note
The indicated data may contain some fractional parts in the values. At the
end of the teaching operation, these fractional parts are truncated.
(9-2) When the component size is not the same as the outward length, correct the
outward length on the outward length graphic image to match.
(9-3) After the modication is completed, press the [Fixed] button.
1303-001
7.3 "COMP RCG" Test Window