5OM-1064-001.pdf - 第11页
Section 1 Recognition Monitor 0005-002 1-1 Tg0250-PM-MD The recognition monitor is used to check how the P .E.C. or the component recognition is performed or to perform the manual alignment operation when P .C.B.’ s cann…
0005-001 8 Tg0250-PM-MD
Section 1
Recognition Monitor
0005-002 1-1 Tg0250-PM-MD
The recognition monitor is used to check how
the P.E.C. or the component recognition is
performed or to perform the manual alignment
operation when P.C.B.’s cannot be recognized
properly.
1. Notes on Use of Recognition Monitor
WARNING
• If anything abnormal should happen, turn off
the power switch of the machine.
Whenever the monitor is discovered in ab-
normal condition (smoke, abnormal sound or
smell, etc.), immediately turn off the power
switch of the machine and disconnect the
power cable from the monitor. In this case,
contact our sales personnel as soon as pos-
sible.
• Do not disassemble any part of the monitor.
High voltage terminations are present within
some enclosures and some housings would
be "hot". A person touching it would get a
dangerous shock or a burn.
• Keep the monitor free of any foreign sub-
stances and liquids in system. Otherwise, a
fire will break out or a person touching it will
get a dangerous electric shock. The monitor
will also break down.
CAUTION
• Be sure to turn off the power switch before
cleaning the monitor. Otherwise, a person
touching the montor will get a dangeous elec-
tric shock.
• Do not use any solvents or chemicals for
cleaning work.
Thinner, benzine, or other abrasives, etc., can
damage the cabinet and the surface of the
screen.
Wax or compressed air should not also be
used for cleaning.
• Do not block the ventilation hole nor put any-
thing around the monitor.
Leave some space (more than 10 cm) around
the monitor.
When the ventilation hole is blocked, the in-
ternal temperature rises extremely, causing
a fire or trouble to the monitor.
1. Notes on Use of Recognition Monitor
0005-002 1-2 Tg0250-PM-MD