TM1467_ReleaseNote_PSC乮Print Stability Control乯-SyringeType-Function.pdf - 第23页
SMT Software Engineeri ng Group IMOperationsYAMAHAMOTORCO. ,LTD. MD OC-SOFT50033 23/30 STEP4 Execut e the initia l solder supply Plea se execute the i nitial s older suppl y by pushin g the “Solder…
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50033
22/30
STEP3 Confirm supplying the solder and setting of supply pressure
Please adjust the pressure of the air regulator on the front of left cover of the machine according to
“Solder Supply Pressure (MPa)” in the window of [Print] – [PSC].
Please move the PSC unit to space easy to operate on the mask so that the solder doesn't fall in the
machine. And then, please push the “Solder Press” button in [Unit] – [PSC], confirm the solder to
supply from solder nozzle point. If not, return to STEP2, and confirm installation of the solder nozzle,
attachment and air joint and setting supply pressure.
Fig.5.4 The appearance of machine and air regulator
Fig.5.5 Confirm the supply pressure
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50033
23/30
STEP4 Execute the initial solder supply
Please execute the initial solder supply by pushing the “Solder Supply” button in [Setup] – [Setup] or
[Unit] – [PSC].
Fig.5.6 The initial solder supply action
STEP5 Execute the Rolling and Test printing
Please execute the Rolling action by pushing the “Rolling” button in [Setup] – [Setup]. At this time,
using board is for the Rolling action. After the Rolling action, please remove the used board.
Please execute the Test-printing by pushing the “Test Print” button in [Setup] – [Setup], and please
decide the printing conditions afterwards.
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50033
24/30
Fig.5.7 [Setup] - [Setup] - [Rolling], [Test Print]
STEP6 Start the production
Please start the Auto-running by pushing the “START” switch on the operation panel.
If the “SOLDER” is displayed in status area, please prepare the new solder of syringe. The solder
syringe can be exchanged smoothly by installing a preliminary supply nozzle in a new syringe
beforehand.
STEP7 Clean after production
When the production is all finished or other kind of the solder is exchanged, please take up the solder
on the mask and clean up the mask, the squeegee, the supply nozzle and the solder cutter. Please detach
and clean the solder cutter fixed with two screws. After it is cleaned, please attach it again.
NOTE: Please do not lose two detached screws.
Fig.5.8 Screw position for solder cutter fixation