00195679-02_AI_XPS_DE+EN.pdf - 第65页
7 Assembly Instructions 2 Operating Safety SIPLACE X-Series Productivity Shuttle T ype I/II 2 Operating Safety NOTE Y ou must review the "Operating Safety" chapt er in the operating instru ctions for the SIPLAC…
1 Assembly Instructions Assembly Instructions
1.7 Safety Information SIPLACE X-Series Productivity Shuttle Type I/II
6
7
Assembly Instructions 2 Operating Safety
SIPLACE X-Series Productivity Shuttle Type I/II
2 Operating Safety
NOTE
You must review the "Operating Safety" chapter in the operating instructions for the SIPLACE
placement system and the SIPLACE X-Series Productivity Shuttles!
WARNING
No actions may be performed without thorough knowledge of the operating instructions of the
SIPLACE placement system and the SIPLACE X-Series Productivity Shuttle. Only trained and
qualified personnel are allowed to carry out actions. Compliance with all warnings, cautions, and
danger notices is mandatory.
DANGER
The SIPLACE Station and the XPS are electrically driven. Therefore, parts of this equipment
conduct dangerous voltages – even when the main switch is switched off! Comply with all
applicable VDE, VDI, and VGB provisions.
Always switch off the main switches of the equipment and disconnect the equipment from the
power supply system if you are performing work on live parts. Failure to comply with any of these
notices can result in death, serious bodily injury, and/or significant property damage!
Comply with all accident prevention regulations and operating instructions applicable to operation
of the equipment. This applies, in particular, to the traversing ranges of lifting and feeding axes.
2 Operating Safety Assembly Instructions
SIPLACE X-Series Productivity Shuttle Type I/II
8
WARNING
You must follow the sequence of the individual assembly steps in order to avoid injuries and/or
property damage.
Do not operate the XPS outside the SIPLACE placement system.
Hands may be crushed in the traversing range of the shuttle.
Prior to commissioning the XPS, always ensure that all coverings have been reattached and
safety devices are active.
Any disconnected ground connection for the coverings must be reconnected.