Flexicut 英文 操作说明书.pdf - 第29页
FL E XIC UT U se r' s G ui de Version 2 28 Clamping possi bi l ities on this table Two clamping devi ces are supplied with the table. To use it you should: Place your sample on the table Place your clamping devi…
FLEXICUT User's Guide
Version 2
27
Cutting page
All the parameters available in the standard mode are available here, except the arm limit switch.
FLEXICUT User's Guide
Version 2
28
Clamping possibilities on this table
Two clamping devices are supplied with the table. To use it you should:
Place your sample on the table
Place your clamping devices, lightly screw (not tighten) the “A” screws in one of the numerous
positions
Screw and tight the “B” screws
Cutting your sample
Hood is closed. Choose the wheel RPM, cooling on/off (button “B”), then press cycle start « A »
The wheel is on.
A
A
B
B
FLEXICUT User's Guide
Version 2
29
Move the lever to cut your part. To improve cut quality, push slowly at a constant speed.
Fixed table Mode
This mode allows the machine to work with an open hood. The wheel speed is limited to 1000 RPM for safety
purposes. NOTE: Only metal bonded diamond or CBN edge wheels are permitted in this mode.
Bath cooling
In this mode, the coolant pump cannot be activated. The wheel can be cooled only by filling the tank with
Presi Coolant 4%. Set the coolant level so that the wheel edge is immersed 10 to 15mm in the fluid.
Table installation
The table is fixed by 3 screws (supplied). As per the mobile table, the arm should be removed.