SMEDBFeeder_UserGuide_EN.pdf - 第36页

2-10 SM-Series SME DB Tape Feeder User's Manual 2.2.2. Fixing the Tape Reel The method to conn ect a reel to the 12~88mm tape feeder is as shown in the following figure: 1) Pull the reel arm plate of the tape feeder…

2-9

Operation of the Feeder

2.2. Installing the SME 12~88mm Feeder Tape

2.2.1. Opening Tape Guide

Press the tape feeder locker in the arrow direction by (1) hand and pull the (2) tape guide

up to open it.

Figure2.12 Opening the SME 12~88mm Tape Guide

Caution When installing a tape in the feeder, exercise care not to have a

finger jammed into the tape guide.

 Do not pull the tape guide up excessively.

 Install the tape in the feeder in the specified order without fail.

 Since the SME 12~88mm tape feeder is heavy, be careful not to

drop it while transporting it.

 Be sure to use a standard tape such as JIS or EIA for the feeder.

 Use only the right size component reel tape for the feeder.

 If the front part and locker of the tape guide are deformed, the

part pickup rate may be reduced. Therefore, exercise great care

when storing and using the feeder.

Caution Dismantling the feeder could cause damage or injury. If a

feeder malfunctions, please contact our CS company (STS)

or local agent.

2-10

SM-Series SME DB Tape Feeder User's Manual

2.2.2. Fixing the Tape Reel

The method to connect a reel to the 12~88mm tape feeder is as shown in the following

figure:

1) Pull the reel arm plate of the tape feeder in the arrow direction until it is secured.

2) Insert the reel into the center of the reel arm post of the reel arm plate.

3) Lift the reel arm plate up backward slightly to unfix the reel arm plate. Then move the

reel arm plate down.

4) Secure the reel brake to the reel.

2-11

Operation of the Feeder

2.2.3. Installing the component tape and Exit of the carrier tape

Have the tape pass through ‘A’ as shown in the following figure.

Figure2.13 Installing path of the tape

Discharge the vinyl tape by selecting one of the front or rear slits of the tape guide.

Figure2.14 Installing the upper cover tape of the feeder( Install the tape through the front/rear slit )