SMEDBFeeder_UserGuide_EN.pdf - 第62页
3-4 SM-Series SME DB Tape Feeder User's Manual in the X direction correctly for t he part pickup position of th e feeder to be adjusted using the calibration jig calibrated by the master feeder su pplied by us and a…
3-3
Maintenance
Figure3.2 SME 8mm/W4P1 Tape Feeder
One of the location pins of a tape feeder is eccentric pin and if it is rotated, the part pickup
position is changed in the direction (X direction) perpendicular to the part feeding
direction (Y direction). If the part pickup position needs to be adjusted, measure the offset
in the X direction correctly for the part pickup position of the feeder to be adjusted using
the calibration jig calibrated by the master feeder supplied by us and adjust the feeder
offset.
One of the location pins of a tape feeder is eccentric pin and if it is rotated, the part pickup
position is changed in the direction (X direction) perpendicular to the part feeding
direction (Y direction). If the part pickup position needs to be adjusted, measure the offset
3-4
SM-Series SME DB Tape Feeder User's Manual
in the X direction correctly for the part pickup position of the feeder to be adjusted using
the calibration jig calibrated by the master feeder supplied by us and adjust the feeder
offset.
Figure3.3 Adjusting the eccentric pin of the SME 8mm/W4P1 tape feeder
Figure3.4 Adjusting the eccentric pin of the SME 12~88mm tape feeder
3-5
Maintenance
3.2. Maintenance of tape feeder
Caution Perform the maintenance of the tape feeder at a clean and
safe place.
Manipulating the tape feeder by applying excessive force
may damage it. Do not manipulate the tape feeder by
applying excessive force.
Ensure that the components of the tape feeder will not be
lost and missing during maintenance and exercise care so
that fingers are not jammed in the feeder during
maintenance.
Table3.1 Checklist
Division
Moving section or
its state
Section to be checked
Periodic
inspection
Common Tape guide Check whether the tape guide
and scraper are bent and
whether it operates properly.
Day
Sprocket Remove foreign materials on the
loading sprockets.
Day
Drain Gear Drain Gear / Roller Day
Feeder base Removing foreign materials on
the feeder base
Day
Etc Abnormal noise/ dust, etc. Day
Vinyl Box Remove foreign materials in the
vinyl box
1 Months
Etc Check the location flange. 1 Months
Power Supply Status Check the status of wear of the
Probe Pin.
1 Months
Check areas subject
to friction
Lubrication of areas subject to
friction
6 Months