SMEDBFeeder_UserGuide_EN.pdf - 第79页
4-9 Trouble Sh ooting Clean the feeder and feeder base slot interfac e connectors and check whether homing and feeding are performed properly Check whether feeder setup unit generates a noise during homing and feedin…
4-8
SM-Series SME DB Tape Feeder User's Manual
Lift the tape guide to check the lower surface of the tape guide and upper surface of
the main body visually
[Measures]
Clean the tape guide.
E0004 Incorrect part supply speed setup
[Cause]
The part to be supplied at low speed mode is supplied at high speed mode
[How to Check]
Check the part supply speed in the ‘Part’ menu of the MMI
[Measures]
Change the part supply speed to low speed mode in the ‘Part’ menu of the MMI.
E0005 Defective feeder maintenance
[Cause]
Foreign materials exist on the sprocket, which disturbs feeding
[How to Check]
Check for existence of foreign materials on the sprocket
[Measures]
Remove the foreign materials on the sprocket and ratchet
E0006 Defective feeding motor operation of the tape feeder
[Cause]
Abnormal power supply to the motor
The board (VCCB) in the docking cart is defective
The clamp drawer connector is defective
Defective feeder motor
Defective contact of the interface connector
Noise is generated from the motor
Defective feeder control board
Defective feeder control board cable
[How to Check]
After checking whether 24V power is applied to the docking cart, check the
connection status of the VCCB cable and clamp drawer connector.
Install the tape again and check whether the homing and feeding of the feeder motor is
performed properly.
4-9
Trouble Shooting
Clean the feeder and feeder base slot interface connectors and check whether homing
and feeding are performed properly
Check whether feeder setup unit generates a noise during homing and feeding, and
check visually the degree of vibration of the sprocket gear when it stops after feeding
Replace the feeder control board and check whether it operates properly
Check whether the feeder board control board cable is properly connected. Replace the
feeder control board cable and check whether the board operates proplerly
[Measures]
Contact our designated C/S company (STS) or local agent
Remove the cause of overload. If there is any problem, contact STS or our local agent
for proper measures.(Replace feeder motor)
Contact our designated C/S company (STS) or local agent. (Replace the interface
connector)
Contact our designated C/S company (STS) or local agent. (Replace the feeder motor)
Contact our designated C/S company (STS) or local agent. (Replace the feeder control
board)
Contact our designated C/S company (STS) or local agent. (Replace the feeder control
board cable)
E0007 Problem with accuracy
[Cause]
Y-axis distorted
[How to Check]
Y-axis precision distorted
[Measures]
Check the feeder for malfunctioning and loss rate using the MMI of the chip mounter.
E0008 Pickup Z setup error occurred.
[Cause]
Pickup height setup is incorrect.
[How to Check]
Check whether the Pickup Z value is appropriate for the corresponding part
[Measures]
Adjust the pickup Z height and pickup speed.
E0009 The down movement for pickup is fast.
[Cause]
4-10
SM-Series SME DB Tape Feeder User's Manual
The part to be placed using the Soft Touch function was placed in the high speed
mode.
The lowering speed when picking up a part to which a problem occurred is set faster
than the normal speed.
[How to Check]
Check whether the corresponding part is the one for which soft touch must be used
Set the lowering speed when picking a part up slower and check whether the same
problem occurs.
[Measures]
Set the Soft Touch function and use it.
Set the lowering speed when picking a part up to slow so that no problem occurs.