00197190-03_VD_SIPLACE_Pro_10_1_SP1_DE_EN.pdf - 第15页
SIPLAC E Pro V10. 1 SP1 / Softwar e Version Desc ripti on Ausgabe 02/2013 Edit ion 15 4 Features of SIPLAC E Pro 10.1 SP1 If not diff erentl y descr ibed, the features of the prev ious SIP LACE Pro vers ions are conta in…
SIPLACE Pro V10.1 SP1 / Software Version Description Ausgabe 02/2013 Edition
14
3.4 New Positions and Supported PCB Widths for Fixed Rails in
SX1/SX2 V2
The following new positions and PCB widths have been implemented for fixed rails in the SX1/SX2
V2 conveyor system:
Fixed Rail Fixed Rail Position PCB Width Distance of Fixed
Rail
Right/Left
Outer
268 250 286
536
Right/Left
259.7
242
277.2
Table 3-1: Fixed rail positions in SX1/SX2 V2
The outer rail position may be set in SIPLACE Pro but is not supported by the 60x station software.
SIPLACE Pro V10.1 SP1 / Software Version Description Ausgabe 02/2013 Edition
15
4 Features of SIPLACE Pro 10.1 SP1
If not differently described, the features of the previous SIPLACE Pro versions are contained in
SIPLACE Pro 10.1 SP1. The main features of SIPLACE Pro 10.1 SP1 are listed below.
● New nozzle types 1008 and 1009.
● New travel profile "38 – Place Down 01005 Component Capacitor".
● Automatic adding of the bottom side of the board.
SIPLACE Pro V10.1 SP1 / Software Version Description Ausgabe 02/2013 Edition
16
5 Features of SIPLACE Pro 10.1
If not differently described, the features of the previous SIPLACE Pro versions are contained in
SIPLACE Pro 10.1. The main features of SIPLACE Pro 10.1 are listed below.
NOTICE
Detailed information about the single functions can be found in the Online Help for
SIPLACE Pro.
5.1 SIPLACE X-Series S – X3 S, X4 S, X4i S Placement Machines
SIPLACE Pro supports the X3 S (three gantries), X4 S and X4i S (four gantries) placement
machines of the new SIPLACE X-Series S.
The MTC2 (on X3 S and X4 S only), 40X and DX component table types are supported.
Smart Pin Support is supported. When Smart Pin Support is used, each gantry has to be equipped
with a pin picker. Additionally, the maximum board length and the setup area are restricted.
The new conveyor system for the SIPLACE X-Series S is supported.
5.2 New Conveyor System for SIPLACE X-Series S
A new conveyor system has been introduced for the SIPLACE X-Series S placement machines.
The new conveyor system consists of five sections: input section, processing section 1,
intermediate section, processing section 2, output section and supports single and dual conveyor
lane mode. Additionally, input and output belt extensions can be configured.
The maximum board length is 450mm (without the Long Board option). The maximum board width
results from the fixed rail position and the conveyor mode (dual or dual as single).
5.3 Station Software Version 706.x
SIPLACE Pro supports the 706.x station software version on the X-, SX- and DX-series placement
machines.