CP-842E-842ME Operator's Guide-Preliminary-CP842-10E.pdf - 第37页
Setting the Recovery Timing/Stop Mode at Recovery Up When Auto Recovery has been selected, recovery timing and stop mode at recovery up must be specified. Procedure 1. Select [Recovery] from the [Main] screen. 2. Select …
Setting the Recovery Limit
When [Machine] is selected as the [Recovery Reference] setting, the number
of recoveries (recovery limit) which are to occur must be specified as
described below.
Procedure
1. Select [Recovery] from the [Main] screen.
2. Select [Auto Recovery].
3. Select [Machine] from the [Recovery Reference] section.
4. Press [Change] in [Recovery Limit].
5. Input the number of times recovery is to be attempted using the
numeric keypad that displays and then press [OK].
6. The numeric keypad will then disappear and the recovery limit
setting will be enabled.
7. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-6 CP-842E/842ME Operator’s Guide
Setting the Recovery Timing/Stop Mode at
Recovery Up
When Auto Recovery has been selected, recovery timing and stop mode at
recovery up must be specified.
Procedure
1. Select [Recovery] from the [Main] screen.
2. Select [Immediate] or [Delayed] from the [Recovery Timing]
section.
3. Select [Stop] or [Continuous] from the [Stop Mode at Recovery
Up] section.
Notes: 1. These settings are available when the recovery mode is set to
[Auto Recovery].
2. Refer to the CP-842E/842ME System Reference manual for
an explanation of recovery modes.
4. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-7CP-842E/842ME Operator’s Guide
Changing the Production Program
Follow the procedure below to change the production program.
Note: Refer to the host computer operation manual for the procedure on how to
transmit production programs.
Procedure
1. Select [Program] from the [Main] screen.
2. Select the production program that is to be used in production
from the list of production program that display.
Note: Production Programs are stored on the hard disk in the machine. The
number of production programs that can be stored on the hard disk will
vary depending on the amount of available disk space. A list of all
production programs stored on the machine can be displayed by scrolling
down in the view window.
3. Press [OK] in the verification dialog box.
4. Press [Close] to return to the [Main] menu screen.
3.2 Production Programs
Chapter 3: Preparing for Production
Preliminary
3-8 CP-842E/842ME Operator’s Guide