CP-842E-842ME Operator's Guide-Preliminary-CP842-10E.pdf - 第45页
Pallet Settings <Option for CP-842ME> Procedure for Pallet Unloading 1. Align the height of the PCU forks (at the end of the PCU) with the fork slots on the machine. T urn the handle and raise the upper section of …
4. Set the feeder on the pallet. Be sure the guide ridge on the
bottom of the feeder fits properly into the slot on the pallet. Push
the feeder forward and then push down to clamp the feeder in
place.
In the case of 13, 15-inch parts reels, fix the reel holder using the steady braces
on the pallet (3 places). Ensure that the feeder itself and the reel holder are in
the same device slot, as failure to set correctly (see feeder A below) can cause
feeder errors.
5. When setting a feeder on a device table, be sure that there is no
foreign matter (waste tape, etc) between the feeder and the
device table. Remove any foreign matter which has adhered to
the device table grooves or to the bottom of the feeder.
Chapter 3: Preparing for Production
Preliminary
3-14 CP-842E/842ME Operator’s Guide
Pallet Settings <Option for CP-842ME>
Procedure for Pallet Unloading
1. Align the height of the PCU forks (at the end of the PCU) with
the fork slots on the machine.
Turn the handle and raise the upper section of the PCU.
Note: Use the label next to the handle to determine the height of the PCU forks.
Adjust the height so that the base of the moveable plate is within ±10 mm
of the label center.
2. Push the PCU to insert the forks into the machine, then clamp
it. Select the [Cange Pallet] command from the [Main] screen,
then press the [Stage1 Clamp].
Note: The setting of a pallet on D1 (Stage 1) is described here.
3. Close the rear door and select the [Stage1 Start] command,
then press the START button.
The D-axis pallet moves to the change position and is unclamped.
Chapter 3: Preparing for Production
Preliminary
3-15CP-842E/842ME Operator’s Guide
4. Open the rear door and pull the pallet out of the machine and
onto the PCU to lock it.
Caution: • Take out the pallet carefully.
• Open and close the cover carefully, as excessive force can damage
the stoppers.
5. Select the [Stage1 Unclamp] command, then slowly retract the
loaded PCU.
CAUTION
Take care when moving a pallet loaded with feeders. A
loaded pallet can be very heavy, and if dropped, may
cause serious injury or damage to personnel or
equipment.
Chapter 3: Preparing for Production
Preliminary
3-16 CP-842E/842ME Operator’s Guide