CP-842E-842ME Operator's Guide-Preliminary-CP842-10E.pdf - 第41页
Selecting the Original T able When either Device Change or Changeover mode is selected, the device table to be used in production first must be selected. Procedure 1. Select [Operation] in the [Main] screen. 2. At the [O…
Setting the Device Table Mode
Select the method in which the device tables are to be used (Table mode) in
accordance with production.
<Explanation of table modes>
Joint mode:
The device tables D1 and D2 are operated together as a single device table.
This mode is used for production programs that have a large number of parts.
Joint resupply mode:
Joint resupply mode is basically the same as the standard joint mode in that
both tables are used in production. However, in joint resupply mode, the table
which is inactive in moved to the retract position until required, and feeders
can be set or removed at this position without interrupting production.
Device Change mode:
One of the device tables D1 or D2 is used in production while the other table
is kept in the standby position for use as a reserve. When a part runs out on
the device table in use, a switch is made to the other device table and
production continues. The relevant device slots on each table must be loaded
with the same parts.
Changeover mode:
One of the device tables D1 or D2 is used for production while parts are
switched on the other to ready it for the next production run.
Note: When either the “Device Change Mode” or the “Changeover Mode” is
selected, the [Original Table] setting described below must also be
specified.
Procedure
1. Select [Operation] from the [Main] screen.
2. Select the table mode that is to be used in production. Select
either "Joint", "Device Change", or "Changeover".
3. Press [Close] to return to the [Main] screen.
3.3 Device Tables
Chapter 3: Preparing for Production
Preliminary
3-10 CP-842E/842ME Operator’s Guide
Selecting the Original Table
When either Device Change or Changeover mode is selected, the device table
to be used in production first must be selected.
Procedure
1. Select [Operation] in the [Main] screen.
2. At the [Original Table] section, selct the device table which has
production priority as either “Stage 1” or “Stage 2”.
3. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-11CP-842E/842ME Operator’s Guide
Part Settings
CP-7-series feeders are compatible with the CP-8-series, however, for certain
reel sizes, a CP-7-series reel holder is required.
Refer to the separate “CP Feeders Mechanical Reference” regarding the
procedure for setting parts.
<Explanation of the feeder stickers>
The sticker that is affixed to the side of each feeder is printed with a code
indicating the standards for that feeder.
Example: W D 08 04 - - - - -
W: Indicates that the feeder can be used on the CP-8 series.
D: This indicates the feeder is a paper tape feeder while "E" represents an
embossed tape feeder.
08: This indicates that a tape with a width of 8 mm can be set on the feeder.
04: This signifies that the pitch of the feeder is 4 mm.
3.4 Parts
Chapter 3: Preparing for Production
Preliminary
3-12 CP-842E/842ME Operator’s Guide