CP-842E-842ME Operator's Guide-Preliminary-CP842-10E.pdf - 第47页
Procedure for Pallet Loading 1. Push the fork of the PCU (containing the replacement pallet) into the machine. Select the [Main], [Change Pallet], and [Stage1 Clamp] command. CAUTION T ake care when moving a pallet loade…
4. Open the rear door and pull the pallet out of the machine and
onto the PCU to lock it.
Caution: • Take out the pallet carefully.
• Open and close the cover carefully, as excessive force can damage
the stoppers.
5. Select the [Stage1 Unclamp] command, then slowly retract the
loaded PCU.
CAUTION
Take care when moving a pallet loaded with feeders. A
loaded pallet can be very heavy, and if dropped, may
cause serious injury or damage to personnel or
equipment.
Chapter 3: Preparing for Production
Preliminary
3-16 CP-842E/842ME Operator’s Guide
Procedure for Pallet Loading
1. Push the fork of the PCU (containing the replacement pallet) into
the machine. Select the [Main], [Change Pallet], and [Stage1
Clamp] command.
CAUTION
Take care when moving a pallet loaded with feeders. A
loaded pallet can be very heavy, and if dropped, may
cause serious injury or damage to personnel or
equipment.
2. Unlock the pallet and gently push the pallet onto the machine’s
D-axis.
Caution: Wide pallets should be held at both ends and pushed into position.
3. Close the rear door and clamp the pallet at the D-axis.
Caution: • Open and close the cover carefully, as excessive force can damage
the stoppers.
• If the safety door is closed while the pallet is being changed, the
clamp will be activated even though the pallet is not in position.
4. Select the [Stage1 Set] command.
5. Select the [Stage1 Unclamp] command, then slowly retract the
PCU.
Chapter 3: Preparing for Production
Preliminary
3-17CP-842E/842ME Operator’s Guide
Nozzle Replacement
Nozzles are set in each nozzle holder on all of the placement heads. The
nozzle holders are numbered from 1 to 6. Refer to the production program
nozzle data to be sure that nozzles are installed correctly. All 16 placement
heads (A - P) must have the same nozzles attached in the same locations.
CAUTION
• To avoid bending, thin nozzles of 0.4 and 0.7 mm in
diameter should be held by the disk when they are
removed from the head.
• Nozzles should be removed carefully to avoid dislodging
and losing the internal spring. After removing the
nozzle, check that the spring has not been left inside the
holder.
3.5 Machine
Chapter 3: Preparing for Production
Preliminary
3-18 CP-842E/842ME Operator’s Guide