00191021-02.pdf - 第165页
User’s Manual Test Program S ITEST 4 Mapping Software Version 403.xx Edition 07/97 4.4 IC Mapping 4 - 13 4.4 IC Mapping NOTE Prior to the perfor mance of IC mappi ng make sure that PCB m apping has alr eady b een car rie…
4 Mapping User’s Manual Test Program SITEST
4.3 RV Mapping Software Version 403.xx Edition 07/97
4 - 12
NOTE
RV mapping can also be performed using the
Calibrate machine...
-->
Head mapping
function (see chapt. 3,
section 3.2). On SIPLACE 80S-20 machine types, this function is used to perform automatically the mapping
procedure, first for gantry 1 and then for gantry 2.
If a dual conveyor is installed on the machine, mapping is performed first on the right and then on the left
conveyor track.
User’s Manual Test Program SITEST 4 Mapping
Software Version 403.xx Edition 07/97 4.4 IC Mapping
4 - 13
4.4 IC Mapping
NOTE
Prior to the performance of IC mapping make sure that PCB mapping has already been carried out.
●
Carry out the preparatory steps as described in section 4.1.
Additional prerequisites are:
–
Segment offset
II
(RV-PCB camera offset) must already have been determined.
–
The calibration tool must be in the calibration tool pocket.
–
The calibration tool position must already have been determined.
–
The IC camera must have been completely calibrated.
–
On the IC head, a type 416 nozzle must be attached.
●
In the main view "SIPLACE 80F
4
" click on the icon to switch to the "IC head" display.
●
Click on the icon to switch to the "IC mapping" display.
Fig. 4.4.1 "IC mapping" Display
4 Mapping User’s Manual Test Program SITEST
4.4 IC Mapping Software Version 403.xx Edition 07/97
4 - 14
The following functions are available in the "IC mapping" display:
–
Right to select the right conveyor track
–
Left to select the left conveyor track of a dual conveyor
–
Start to start the mapping run
–
Continue to continue mapping
–
Display mapping data to display the mapping data determined
●
Click on the
Start
button.
The gantry performs the mapping run. After the mapping run has been completed without any errors,
the data thus determined is automatically saved.
●
If a dual conveyor is installed, activate the radio button for the conveyor track for which mapping has
not yet been performed.
●
Click again on the
Start
button. The gantry performs the mapping run on the selected conveyor track.
After the mapping run has been completed without any errors, the data thus determined is automatically
saved.
●
Click on the icon to return to the main view.
NOTE
IC mapping can also be started using the
Calibrate machine...
-->
Head mapping
function (see chapt. 3,
section 3.2). First the RV mapping is performed, then the IC mapping.