00193463-01.pdf - 第143页
User Manual SIPLAC E S-25 HM 4 Component han dling Software Vers ion SR.503.xx 04/2002 US Edition 4.4 Tape co ntainer 143 4.4 T ape cont ainer 4.4. 1 Ove rview Reels up to 15" in diameter may be used, al though for …
4 Component handling User Manual SIPLACE S-25 HM
4.3 Setting up the feeders Software Version SR.503.xx 04/2002 US Edition
142
4
Fig. 4.3 - 1 Inserting 30 or 45 mm wide feeders on the component table
(1) Feeder, 30 mm wide
(2) Feeder, 45 mm wide
(3) Feeder, 30 mm wide
(4) Centering ball
(5) Component table
User Manual SIPLACE S-25 HM 4 Component handling
Software Version SR.503.xx 04/2002 US Edition 4.4 Tape container
143
4.4 Tape container
4.4.1 Overview
Reels up to 15" in diameter may be used, although for 15" reels you should use spindles as well.
Insert the spindles into the partitions as shown in Fig. 4.4 - 1. 4
PLEASE NOTE 4
We recommend that you use spindles if the tape reel diameter exceeds 5". This will ensure that
the feeders operate reliably. 4
Fig. 4.4 - 1 Component table and tape container
(1) Component changeover table
(2) Spindle
(3) Waste tape container
(4) Partition
(5) Tape container
4 Component handling User Manual SIPLACE S-25 HM
4.5 Used tape cutter Software Version SR.503.xx 04/2002 US Edition
144
4.5 Used tape cutter
4.5.1 General
The placement system has a used tape cutter at each of the two component table locations. It is
used to cut off the waste tape. The cut pieces of tape drop into the waste tape container in the
component table. 4
Æ Empty the waste tape container every day.
Fig. 4.5 - 1 Used tape cutter
(1) Stationary cutting blade
(2) Retainer
(3) Moving cutting blade
(4) Electronic control unit
(5) Short stroke cylinder