JO-072-006_w.pdf - 第50页
2-13 AKBEG-ID (4) After the registration (jig origin adjustment) of the master position is completed, the following window opens, enabling you to perform a feeder measurement. Reference Refer to "2. Feeder Measureme…
2-12
AKBEG-ID
(2) After a few seconds, the [Master Setting] button appears.
Fig. B16
(3) Press the [Master Setting] button and proceed to the registration of the
master position (jig origin adjustment).
Reference
Refer to "1. Registration of Master Position (Jig Origin Adjustment)" in "Section
4" for how to adjust the jig to the origin position.
2.1 Starting the Program
0809-001
2-13
AKBEG-ID
(4) After the registration (jig origin adjustment) of the master position is
completed, the following window opens, enabling you to perform a
feeder measurement.
Reference
Refer to "2. Feeder Measurement" in "Section 4" for how to measure a feeder.
Fig. B17
0809-001
2.1 Starting the Program
2-14
AKBEG-ID
2.2 Ending the Program
(1) Press the [ ] button located on the upper right side of each window.
(2) The "Exit Conrmation" dialog box opens. Press the [Yes] or the
[Cancel] button.
When you select the [Yes] button, you can exit from t
he program.
Selecting the [Cancel] button resumes the origin window.
Fig. B18
When the Windows shutdown function is valid (default), the "Windows" system
program also closes.
To invalidate the function, the authority higher than the power user is
required.
Tick the check box "Windows Shutdown after Exiting" located on
the lower left side of the "Exit Conrmation" dialog box. The "Tick"
mark disappears.
When the program is started again, press the [
] icon on the desktop
of the personal computer.
0809-001
2.2 Ending the Program
Procedure