JO-072-006_w.pdf - 第85页
4-B AKBEG-ID 0508-001
4-A
AKBEG-ID
0508-001
Section 4
Feeder Measurement
This section describes how to measure the feeders.
•
Registration of Master Position (Jig Origin Adjustment)
•
Feeder Measurement
•
Measurement of Pickup Position Height
•
Default Setting of Program for Feeder Measurement
4-B
AKBEG-ID
0508-001
4-1
AKBEG-ID
0508-001
1. Registration of Master Position (Jig Origin Adjustment)
1. Registration of Master Position
(Jig Origin Adjustment)
Set the power of the electrical box to "ON", turn on the power of the person-
al computer, and start up the program for the feeder adjusting jig.
Notice
When the power of the electrical box is turned "OFF" with the power
of the personal computer "ON", the power supplied to the personal
computer is also turned "OFF, causing the personal computer to
break down.
Procedure
(1) Check to see that no dirt and dust adhere to the mounting face of the
adjustment base and the bottom of the pickup position master. After the
conrmation, set the pickup position master on the jig adjustment base.
Note that the pins of the adjustment base must be inserted securely into
the holes of the pickup position master
.
CAUTION
•
The pickup position master is very heavy. Be sure
not to drop it. Otherwise, your feet will get hurt or
the jig may be damaged.
•
The LED illumination unit uses a Cass 2 laser
beam. Do not expose your eyes directly the laser
radiation. Otherwise, your eyes will be injured.
Pickup Position Master
Holes
Adjustment Base
Pins
Fig. D1