00197674-01-UM-E-Series-EN-12-2014.pdf - 第164页
3 Technical data and assemblies User manual SIPLACE E 3.10 Changeover table for SIPLACE E From software version SC 708.0 12/2014 Edition 164
User manual SIPLACE E 3 Technical data and assemblies
From software version SC 708.0 12/2014 Edition 3.10 Changeover table for SIPLACE E
163
3
Fig. 3.10 - 9 Empty tape duct on the SIPLACE E changeover table COT insert
(1) Inlet slot for used tape
(2) Outlet slot for the used tape above the pneumatic tape cutter
(3) Empty tape duct < 12 mm up to 25 mm (can be removed for tapes > 12 mm)
The empty tape duct can guide component tapes with a maximum pocket height of 12 mm. If
feeder modules which use tapes with a pocket height of > 12 mm are used, use the 25 mm
empty tape duct.
3
PLEASE NOTE
Risk of blockages!
When using feeder modules with low pockets next to feeder modules with high pockets,
there is a risk of blockages in the empty tapes.
Do not position feeder modules with shallow pockets immediately beside feeder mod-
ules with deep pockets.
(1)
(2)
(3)
3 Technical data and assemblies User manual SIPLACE E
3.10 Changeover table for SIPLACE E From software version SC 708.0 12/2014 Edition
164
User manual SIPLACE E 4 Setting up and commissioning
From software version SC 708.0 12/2014 Edition 4.1 Transportation and delivery configuration
165
4 Setting up and commissioning
4.1 Transportation and delivery configuration
4.1.1 Shipping packaging
Within Europe, the machine and changeover tables will be shipped on two wooden pallets, pack-
aged in plastic film. Outside Europe, the machine and changeover tables are supplied in wooden
crates.
4.1.1.1 Shipping packaging dimensions
The dimensions of the pallets and wooden crates are listed in the following table:
4
Fig. 4.1 - 1 Transport crate - dimensions in millimeters
(A) Pallet jack attachment points
Machine (L x W x H) Changeover table (L x W x H)
Wooden
crate
2430 mm x 1530 mm x 1620 mm 1050 mm x 1050 mm x 1150 mm