00197674-01-UM-E-Series-EN-12-2014.pdf - 第237页
User manual SIPLACE E 5 Working with the machine From software version SC 708.0 12/2014 Edition 5.11 Setting up t he feeder modules 237 Step3 5 5 Fig. 5.11 - 6 Guiding the cover foil to the foil packing wheels (1) Cover …
5 Working with the machine User manual SIPLACE E
5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition
236
Step2 5
5
Fig. 5.11 - 5 Pickup window on the feeder module
(1) Tape support, removable (see section 5.11.4.4, page 238)
(2) Pickup window
(3) Removal edge for the cover foil
(4) Component pickup area
(5) Lever for raising and latching the pick-up window
Guide the start of the tape beneath the pickup window (item 2) and further until the compo-
nent tape is touching the sprocket wheel.
On the operator panel, press the FORWARD button until the bend of the cover foil is in the
component pickup area (item 4).
Push the lever (item 5) forward in order to raise the pickup window (item 2) into the first latch-
ing position.
Pull the cover foil at the side of the pick-up window forward and out.
Fold the cover foil back until it lies against the removal edge (item 3).
5
Push the lever (item 5) back to lower the pickup window.
PLEASE NOTE
Do not lower the pick-up window until the cover foil is lying against the pull-off edge.
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.11 Setting up the feeder modules
237
Step3 5
5
Fig. 5.11 - 6 Guiding the cover foil to the foil packing wheels
(1) Cover foil packing wheels
(2) Cover foil rocker
5
Guide the cover foil over the cover foil rocker (item 2) until it reaches the foil packing wheels
(item 1).
On the operator panel, press the FOIL button until the cover foil is tensioned. The cover foil
rocker points down and stops the drive motor.
Cut the component tape flush with the front end of the feeder module.
5 Working with the machine User manual SIPLACE E
5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition
238
5.11.4.4 Tape support for SIPLACE SmartFeeder 8 mm E module
5
Fig. 5.11 - 7 SIPLACE SmartFeeder 8 mm E - tape support
(1) Tape support, removable
(2) Oval opening in the tape support
The SIPLACE SmartFeeder E is equipped with a tape support (item 1 in fig. 5.11 - 7). It can easily
be removed if necessary.
Insert the tang of a watchmaker's screwdriver into the oval opening (item 2 in fig. 5.11 - 7) in
the tape support and pull the tape support out against the direction of travel of the tape.
When you insert the tape support, make sure that it engages in its desired position.
5
PLEASE NOTE
Constant Z pickup height and reduction of time used to correct pickup heights
For all components size 0402 and smaller, always insert the tape support (item 1 in
fig. 5.11 - 7) into the feeder module.