00197674-01-UM-E-Series-EN-12-2014.pdf - 第230页
5 Working with the machine User manual SIPLACE E 5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition 230 On standby, the status display (item 2) lights up g reen if the feeder module is cont…
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.11 Setting up the feeder modules
229
5.11 Setting up the feeder modules
5.11.1 Notes on handling feeder modules
Feeder modules are precision devices. You should therefore handle the feeder modules with care.
Avoid bumping feeder modules into obstacles.
Do not drop the feeder modules.
Always use suitable tools for cleaning and checking.
5.11.2 Removing SIPLACE SmartFeeder E from the changeover table
5
Fig. 5.11 - 1 Removing SIPLACE SmartFeeder E from the changeover table
(1) Removal handle
(2) Status display
(3) Feeder locking bar
(4) Stop bar
(5) Centering bar
(1)
(2)
(5)
(4)
(3)
5 Working with the machine User manual SIPLACE E
5.11 Setting up the feeder modules From software version SC 708.0 12/2014 Edition
230
On standby, the status display (item 2) lights up green if the feeder module is contained in the cur-
rent setup. If the feeder module is not contained in the current setup, the status display remains
off.
The SIPLACE SmartFeeder E is locked in position in the changeover table by a latch. The proce-
dure for removing feeder modules from the changeover table is as follows:
Pull the removal handle (item 1). The status display goes red and then the status display
goes out.
Use the removal handle to pull the feeder module out of the locking bar (item 3) and stop
bar (item 4).
Remove the feeder module. Pay attention to the centering bar (item 5).
User manual SIPLACE E 5 Working with the machine
From software version SC 708.0 12/2014 Edition 5.11 Setting up the feeder modules
231
5.11.3 Using the SIPLACE SmartFeeder E
5.11.3.1 Check the SIPLACE SmartFeeder E before using it
5
Fig. 5.11 - 2 Check the SIPLACE SmartFeeder E before using it
(1) Cover foil rocker
(2) Pickup window
(3) Lever for raising and latching the pick-up window
Check the following points before you use a feeder module on the changeover table:
The feeder module must be in perfect condition.
Tap the cover foil rocker (item 1) lightly to make sure that it has not jammed.
Check that the area around the pickup window (item 2) is free from loose components.
Press the lever (item 3) forward slightly to open the pickup window (item 2). This will raise the
pick-up window slightly.
5
PLEASE NOTE
The tensioned cover foil continues to transport the tape when the tape has been inserted
and exposes the components.
Do not press the lever if a component tape is inserted.
(1)
(2)
(3)