00197815-04_JC_PM_WF2_SX12_EN.pdf - 第33页
8 WF2 SX1/2 Clean the Y-Axis loose bearing, contact surface and scale and replace the lubrication system. 2.75 min 1 / 2 C A U T I O N ! R e f e r t o s a f e t y i n s t r u c t i o n s i n u s e r m a n u a l b e f o…
www.asm-smt.com
8 WF2 SX1/2 Clean the Y-Axis loose bearing, contact surface and scale and replace
the lubrication system.
2.75 min 1 / 2
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Transport Empty
NOTICE! ESD guidelines are to be followed Tool:
T13
Wear Part: Consumables:
C3, C5, C7, C31
www.asm-smt.com
1 Move all gantries to the end limit. 2 Unscrew the outer lubrication system at
the left side of the gantry.
3 Unscrew the inner lubrication system at
the left side of the gantry.
4 Clean the outer loose bearing at the left
side of gantry.
5 Clean the inner loose bearing at the right
side of gantry.
6 Clean the contact surface over the entire
length.
8 WF2 SX1/2 Clean the Y-Axis loose bearing, contact surface and scale and replace
the lubrication system.
2.75 min 2 / 2
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Transport Empty
NOTICE! ESD guidelines are to be followed Tool:
T13
Wear Part: Consumables:
C3, C5, C7, C31
www.asm-smt.com
7 Unscrew the protective caps. 8 Screw in the new outer lubrication system
at the left side of the gantry.
9 Screw in the new inner lubrication system
at the left front of the gantry.
10 Clean the Y-axis scale over the entire
length.
11 Repeat steps 1 to 8 at the other gantry.