754_____cmeng0000.pdf - 第9页
1 Introduction This manual contains data necessary to do performance verification tests and calibration adjustments on your 753 and 754 Documen ting Process Calibrators (the Product). How to Contact Fluke To contact Fluk…
753/754
Calibration Manual
vi
1
Introduction
This manual contains data necessary to do performance verification tests and calibration
adjustments on your 753 and 754 Documenting Process Calibrators (the Product).
How to Contact Fluke
To contact Fluke, call one of the following telephone numbers:
• Technical Support USA: 1-800-44-FLUKE (1-800-443-5853)
• Calibration/Repair USA: 1-888-99-FLUKE (1-888-993-5853)
• Canada: 1-800-36-FLUKE (1-800-363-5853)
• Europe: +31 402-675-200
• Japan: +81-3-6714-3114
• Singapore: +65-738-5655
• Anywhere in the world: +1-425-446-5500
Or, visit Fluke’s website at www.fluke.com
To register your product, visit http://register.fluke.com
To view, print, or download the latest manual supplement, visit
http://us.fluke.com/usen/support/manuals
The latest software trial version of DPCTrack2 can be downloaded at
www.fluke.com/DPCTrack . For more information see “Communication with a PC”.
753/754 Accessories can be found at www.fluke.com/process_acc
753/754
Calibration Manual
2
Safety Information
A Warning identifies condition and procedures that are dangerous to the user. A Caution
identifies conditions and procedures that can cause damage to the Product or the
equipment under test.
XW Warning
To prevent personal injury, use the Product only as
specified, or the protection supplied by the Product can be
compromised.
To prevent possible electrical shock, fire, or personal injury:
• Read all safety Information before you use the
Product.
• Carefully read all instructions.
• Use only correct measurement category (CAT),
voltage, and amperage rated probes, test leads, and
adapters for the measurement.
• The battery must be locked in place before you
operate the Product.
• Recharge the battery when the low battery indicator
shows to prevent incorrect measurements.
• Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
• Limit operation to the specified measurement
category, voltage, or amperage ratings.
• Do not exceed the Measurement Category (CAT)
rating of the lowest rated individual component of a
Product, probe, or accessory.
• Measure a known voltage first to make sure that the
Product operates correctly.
• Do not touch voltages > 30 V ac rms, 42 V ac peak, or
60 V dc.
• Do not use the Product around explosive gas, vapor,
or in damp or wet environments.
• Do not use, and disable the Product if it is damaged.
• Do not use the Product if it operates incorrectly.
• Keep fingers behind the finger guards on the probes.
• Remove all probes, test leads, and accessories that
are not necessary for the measurement.
• Only use probes, test leads, and accessories that
have the same measurement category, voltage, and
amperage ratings as the Product.