OM-1273-004_w.pdf - 第139页

4-10 AJK-ML T-ID 0706-002 3.3 Inspection, Cleaning, and Lubrication Spots 3.3 Inspection, Cleaning, and Lubrication Spots The following describes about the maintenance tasks required for each individual units. Reference …

100%1 / 213
4-9
AJK-MLT-ID
3.2 Understanding of Maintenance Items on Each Section
0706-002
3.2 Understanding of Maintenance Items on Each Section
The following describes how to view the description of each eld (numbered
elds) in "3.3 Inspection, Cleaning, and Lubrication Spots".
View of Inspection, Cleaning, and Lubrication Spots
(Exampleof
Identication)
Pallet
Every Month Inspection and Cleaning
Required Time: 1 minute
When the pallet is dirty, clean both top and
bottom surfaces with a rag.
Top Surface
Every 3 Months Inspection
Required Time: 1 minute
Check for the warpage of the pallet with a
scale. (Up to Max. 0.5 mm)
Rails
Every 3 Months Inspection
Required Time: 2 minutes
Check the wear of the bottom surfaces of
the pallet rails with a scale.
(Up to Max. 0.5 mm)
[1]
[4]
[3][2]
Fig. D3
[1]:
Maintenance Spot
[2]:
Cycle and Contents of Maintenance
[3]:
Details of Maintenance
[4]:
This indicates roughly estimated time required for maintenance work.
(This is included in the time required to attach or detach a cover, etc.)
4-10
AJK-MLT-ID
0706-002
3.3 Inspection, Cleaning, and Lubrication Spots
3.3 Inspection, Cleaning, and Lubrication Spots
The following describes about the maintenance tasks required for each
individual units.
Reference
Refer to "2. Maintenance Check List" for the maintenance items classied
based on frequency.
3.3.1 Pallet
.OTE
When the pallet is warped, the component pickup rate may deteriorate.
Pallet
Every Month Inspection and Cleaning
Required Time: 1 minute
When the pallet is dirty, clean both top and
bottom surfaces with a rag.
Top Surface
Every 3 Months Inspection
Required Time: 1 minute
Check for the warpage of the pallet with a
scale. (Up to Max. 0.5 mm)
Rails
Every 3 Months Inspection
Required Time: 2 minutes
Check the wear of the bottom surfaces of
the pallet rails with a scale.
(Up to Max. 0.5 mm)
Fig. D4 Pallet
4-11
AJK-MLT-ID
0706-002
3.3.2 Elevator Shaft
Before the maintenance work, manually move the elevator to the position for
easier lubrication work and turn off the power.
The maintenance cover must be detached to apply grease to the elevator
shaft.
Reference
Refer to "4.1 Detachment and Attachment of Maintenance Cover" for how
to detach the cover.
Ball Screw
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 10 minutes
Wipe off old grease with an oiled rag and
apply new one with a brush.
Take ample care not to leave any
waste threads after cleaning.
Notice
Fig. D5
3.3 Inspection, Cleaning, and Lubrication Spots