OM-1273-004_w.pdf - 第48页
1-11 AJK-ML T-ID Rack Shutter Rack Shutter MG-G1 10 MG-G1 15 Magazine Door Magazine Door Fig. A2 Magazine Pallet (MP-G100) T ray Magnet (MF-G100) Fig. A3 Pallet and T ray Magnet W A R N I N G Do not bring the tray magnet…
1-10
AJK-MLT-ID
0706-002
3. Name of Each Section and Handling
3. Name of Each Section and Handling
This feeder is constructed of an elevator, magazines, a traverse, pallets, and
tray magnets.
WARNING
There are strong motorized and high-voltage areas inside the
machine. Special caution should be paid not to touch them.
Doing otherwise will cause personal injury (serious accident).
·
Onlyqualied
maintenancepersonnelshoulddetach
the covers.
·
The machine should be operated with the covers
being attached.
·
If a cover is detached, be sure to reattach it.
·
Be sure to close the magazine door before operating
the machine.
·
Do not disengage the interlock of the magazine door.
Elevator
Elevator Power LED
Magazine #2 Supply Position
Upper Magazine
Change Position
Magazine Change Position
Magazine #1 Supply Position
Lower Magazine
Change Position
Traverse
Magazine #2 Door
Exchange Position Door
Magazine #1 Door
Magazine #2 Ready Switch
Exchange Position
Ready Switch
Magazine #1 Ready Switch
Fig. A1 Multi-Layer Tray Feeder (Front Side of Machine)
1-11
AJK-MLT-ID
Rack Shutter
Rack Shutter
MG-G110MG-G115
Magazine Door Magazine Door
Fig. A2 Magazine
Pallet (MP-G100)
Tray Magnet
(MF-G100)
Fig. A3 Pallet and Tray Magnet
WARNING
Do not bring the tray magnet close to the area where a
pacemaker is implanted. Otherwise, the pacemaker may be
affected by the magnetism and a serious accident will result.
0706-002
3. Name of Each Section and Handling
1-12
AJK-MLT-ID
0706-002
3.1 Layout of Main Machine
CAUTION
Do not bring a magnetic card or a watch close the tray magnets.
Otherwise, the data of the magnetic card might be cleared or a watch,
etc., may be damaged due to the strong magnetism.
Handle the pallets carefully.
Otherwise, the pallets may be deformed.
·
Do not drop the pallet onto the oor, etc.
·
Do not apply any force partially to any area of the pallet.
·
Do not store the pallets in a pile.
When a deformed pallet is used, a component pickup error may occur.
When a component pickup error occurs frequently, replace the pallet
with a new one.
3.1 Layout of Main Machine
When "FP-G200" is installed on the main machine, the layout of the installed
stage will be changed.
Component Recognition
Camera
Coplanarity
Check Unit (Option)
Placement Head (Multifunctional Head (Option))
Traverse
Fig. A4