00196378-0102_UM X-Feeder_EN.pdf - 第46页
Operating Tape Feeder Modules Inserting the Feeder Module into the Co mponent Table 46 User Manual X Feeder Modules SIPLACE Family ► (1) Place the feede r module wit h t he front sliding guide onto the O mega profile o f…
Operating Tape Feeder Modules
Inserting the Feeder Module into the Component Table
User Manual X Feeder Modules SIPLACE Family 45
4 Operating Tape Feeder Modules
4.1 Inserting the Feeder Module into the Component Table
The following figure gives an overview of the component table elements that have to be considered for
correctly inserting the feeder modules.
Legend
1. Centering holes – front
2. Centering – front
3. Omega profile = Low feeder guide rails
4. Centering bar – rear
Operating Tape Feeder Modules
Inserting the Feeder Module into the Component Table
46 User Manual X Feeder Modules SIPLACE Family
►(1) Place the feeder module with the front sliding guide onto the Omega profile of the component table
that is appropriate for the desired track.
►(2) Vertically push the feeder module forward on the guide until the front centering pin engages at the
component table.
►(3) Make sure that the rear centering pin stands in the correct recess of the rear centering bar that
corresponds to the front centering pin.
►(4) The login procedure is started. The status display at the rear end of the feeder module lights up
green when the login procedure has been completed successfully, when the feeder module is includ-
ed in the current setup and installed on the correct track.
Operating Tape Feeder Modules
Inserting / Removing the Spacer (Tape Support) Setting Up the Feeder Module
User Manual X Feeder Modules SIPLACE Family 47
4.2 Setting Up the Feeder Module
4.2.1 Inserting / Removing the Spacer (Tape Support)
4.2.1.1 Spacer on 2x8 mm Feeder Modules
Inserting the Spacer
►(1) X feeder spacer
►(2) Open the pickup window and insert the spacer into the track.
►(3) Push the spacer forward under the pickup window.
►(4) The pin on the rear side of the spacer must sit in the centering hole in the track channel.
NOTICE
A spacer (tape support only for paper tapes) should be installed if components of size 0402, or
smaller, are set up. The spacer should also be used if the components in a paper tape are pro-
grammed to use non-contact pickup.