00196378-0102_UM X-Feeder_EN.pdf - 第54页
Operating Tape Feeder Modules Setting Up the Feeder Modu le Inserting the Tape 54 User Manual X Feeder Modules SIPLACE Family Opening the pickup window ► Press the front part of the pickup window from above. The back par…
Operating Tape Feeder Modules
Inserting the Tape Setting Up the Feeder Module
User Manual X Feeder Modules SIPLACE Family 53
4.2.4 Inserting the Tape
4.2.4.1 Inserting the Tape on 2x8 mm Feeder Modules
►(1) Cut the tape at right angles and fold the protruding cover foil down backwards. Insert the beginning
of the tape into the empty tape duct.
►(2) The tape will reappear at the top opening of the empty tape duct.
►(3) Open the pickup window by pressing it down. Push the tape further on up to the middle of the
pickup window. (See also below)
►(4) Let the tape engage in the toothed wheel by releasing the pickup window.
Pickup Window on 2x8 mm Feeder Modules
NOTICE
There is a small gap in the pickup window, behind the removal edge. This is another removal
edge. The second removal edge can be used for tapes with adhesive cover foils. The compo-
nents then remain in the tape and are not taken off by the cover foil.
Legend
1. Pressure spring
2. Pressure bracket
3. Pickup window
4. Toggle
If you press the front part of the pickup window, this lifts
the back part of the pickup window over the sprocket
wheel.
The toggle is used to lock the pickup window in the top
position.
Operating Tape Feeder Modules
Setting Up the Feeder Module Inserting the Tape
54 User Manual X Feeder Modules SIPLACE Family
Opening the pickup window
►Press the front part of the pickup window from above. The back part of the pickup window will move
up. The pickup window is now in the top position.
►Flip the toggle forwards.
►Release the front part of the pickup window. The pickup window will remain in the top position. You
can now easily insert or remove the component tape.
Closing the pickup window
►Press the front part of the pickup window from above. The back part of the pickup window will move
up.
►Flip the toggle backwards.
►Slowly release the front part of the pickup window. The pickup window will move down to the bottom
position. This fixes the component tape in the sprocket wheel.
4.2.4.2 Inserting the Tape on 8 - 88 mm Feeder Modules
►(1) Insert the tape at the rear end of the feeder module into the empty tape duct and push it forwards.
►(2) Fold the protruding cover foil backwards.
►(3) Press the lever forwards.
►(4) Push the tape under the pickup window until the stop. Press and re-press the Forwards button
until the tape and the foil are under the pickup window.
Operating Tape Feeder Modules
Inserting the Tape Setting Up the Feeder Module
User Manual X Feeder Modules SIPLACE Family 55
►(5) Direct the excess cover foil past the side of the pickup window.
►(6) Direct the excess cover foil past the tape lift and around the pickup window.
►(7) Press and re-press the Backwards button until the cover foil reaches the foil removal edge and
the first component is at the correct pickup position.
►(8) Press the lever backwards.