OM-1833-001w_SL.pdf - 第113页
1504-001 Remedy : Remove any chip component or foreign substance such as debris attached onto the sprocket and completely clean the sprocket. Cause : Chip component or foreign substances including debris have been attach…
1504-001
9.3 Tape Feed not correctly performed
NG
OK
The sprocket gears do not engage with the perforations.
Remedy
: Unload the tape and process the tape end correctly, and then load it again.
Cause : Carrier Tape Sprocket Hole not engaged with the sprocket teeth.
9.3 Tape Feed not correctly performed
Refer to "2.4 Tape End Processing Procedure" for the tape end processing procedure.
Keep them clean.
Reference
Remedy
: Remove any chip component or foreign substance such as debris attached onto the
suppressor and completely clean the suppressor.
Notice
If the taping component is mounted with any foreign substance attached, the suppressor
might be deformed or a pick-up error occur.
Therefore, clean it.
Cause : Chip component or foreign substances including debris have been
attached inside the suppressor and the suppressor does not securely
hold the tape.
Foreign Substance
OM-1833
9-4
1504-001
Remedy
: Remove any chip component or foreign substance such as debris attached onto the
sprocket and completely clean the sprocket.
Cause : Chip component or foreign substances including debris have been
attached onto the sprocket and the sprocket does not rotate.
Remedy
: Remove any chip component or foreign substance such as debris attached on the chute
and completely clean the surface of the chute.
Foreign Substance
If the taping component is mounted with any foreign substance attached, the suppressor
might be deformed or a pick-up error occur.
Therefore, clean it.
Cause : Because an alien substance such as a chip component or debris has
been attached to the sprocket, the sprocket cannot rotate.
9.3 Tape Feed not correctly performed
Foreign Substance
Notice
OM-1833
9-5
9.4 Normal Loading Operation is not available
Remedy
: Set the tape again up to the sprocket (3).
Set the tape to the position much deeper
than the sprocket (3) summit position.
Cause : The tape has not been set up to the correct position.
Remedy
: Set the loading suppressor again up to the correct position.
NG
OK
The loading suppressor has not been locked.
Cause : The loading suppressor has not been set up to the correct position.
1504-001
9.4 Normal Loading Operation is not available
OM-1833
9-6